2. Stone & Beam
  3. IPL534A01ORB-A

Stone & Beam IPL534A01ORB-A User manual

  • Hello! I am an AI chatbot trained to assist you with the Stone & Beam IPL534A01ORB-A User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Model# IPL534A01ORB-A
04-18
Welcome Guide
Part Qty
Part 7 (ex. Fixture Body)
Part 1 (ex. Wire Nuts)
3
Part 2 (ex. Mounng Bracket)
1
Part 3 (ex. Star Washers)
2
2
Part 4 (ex. Cap Nuts)
Part 5 (ex. Canopy)
Part 6 (ex. Rods)
Part 9 (ex. Glass)
Part 10 (ex. Bulb)
1
1
1
1
Model# IPL534A01ORB-A
Contents:
Before geng started, ensure the package contains the following components:
1
2
3
4
5
6
7
8
9
10
2x6”
+
3x12”
1
Part 8 (ex.
Spinner Nut
)
Sleeve
Swivel
Assembly Instrucons
Step 1: Install the length of rod(s) (6) that is required by threading wire through the rod(s) (6) and screwing it
to the fixture body (7). Install swivel to the rod(s) (6) ensuring that the sleeve is at the swivel.
Tools And Materials Required
Phillips
Screwdriver
Wire Cuers
Pliers Wrench
Wiring supplies as
required by local
electrical code
Step 2: Loosen hex nuts. Adjust stud to desired length and lock in place with hex nuts.
Studs
Step 3: Mount the mounng bracket (2) to electrical box using electrical box screws (not included).
Make sure the studs on the mounng bracket (2) are facing out from the electrical box.
Electrical Box Screws
(not included)
6
7
Hex Nut
2
2
Electrical
Box
Assembly Instrucons
Step 4: Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or
ground screw in the electrical box. Connect black wire from fixture to black wire in electrical box and connect the white
wire from fixture to white wire in electrical box.
Once connecons of wires are completed, carefully tuck wires and wire nuts (1) into the electrical box making sure no
bare wire (on the black and white) is visible at the wire nuts (1).
White
Black
House supply
Ground wire
Fixture
Ground wire
1
1
5
Stud
Step 6: Remove spinner nut from socket. Posion glass (9) on lamp and secure with spinner nut (8).
Install specified bulb (10) type and waage.
5
3
4
Step 5: Posion fixture over studs on mounng bracket (2) assembly. Secure fixture in place with star washers (3)
and cap nuts (4).
9
10
8
Cleaning and Maintenance
• To clean, turn off and wipe with a damp, non-abrasive cloth.
• When cleaning, use only a so brush or lint free cloth to avoid scratching the finish.
• Abrasive cleaning agents are not required and should be avoided to prevent damage
to finish.
Safety
• Turn off electrical power before starng installaon of light fixture.
• This product must be installed in accordance with the applicable installaon code by a
person familiar with the construcon and operaon of the product and the hazards involved.
• Connect the ground wires (bare copper or green) from your fixture to the ground wire
(bare copper or green) or ground screw in the electrical box.
/