TruAire 118RB Installation guide

Steel Sunburst Baseboard Grille and Register Installation

Instructions

Page 1 of 2

Step 1

Remove the face of the grille/registers. With the grille/register sitting on a table, facing you, place the tip of

each of your index fingers under the tabs located in the upper corners. Place your thumbs on top of the

grille/registers. Using your index fingers, pull the top of the face toward you.

Steel Sunburst Baseboard Grille and Register Installation

Instructions

Page 2 of 2

Step 2

Position the grille/register over the duct opening in the floor.

Step 3

Using the screws that were provided, secure the base of the sunburst baseboard grille/register to the floor

and/or wall.

Step 4

To repalce face, first align tabs on base with slot on bottom of face. Pivot face up and snap closed.