3/4 X 2 ADIRONDACK PIN HDPE
A - 1/4-20 X 2-1/4 WAFER SHCS
Step 1
Correct
nut
washer
4MM HEX KEY, ALLEN, T-HANDLE
(INCLUDED)
11/19/2012
ASSEMBLY INSTRUCTIONS
Incorrect
Step 2
Unfold chair assembly
Step 2
A/B
A/B
Step 1
HARDWAREISCOATEDSTAINLESSSTEELUNLESSOTHERWISESPECIFIED
TOOLS NEEDED
Model: IVAD5030
2
2
2
Insert (2) 2¼" bolts, washers and locknuts
into pre-drill holes
Then insert pins
2
Qty. Description
bolt
B - 1/4 FLAT WASHER
B - 1/4-20 NYLOCK NUT
leg
C - .27 X 2-1/2 WAFER SOCKET "A"
8
D - .27 X 3 WAFER SOCKET "A"
6
FINE THREAD
B - 1/4-20 X 2-1/2 WAFER SHCS
4
A - 1/4-20 X 1-1/2 WAFER SHCS
FINE THREAD
1
__(1) Hardware pack
the umbrella brace.
Models: IVRCT236, IVRBT236
fine thread
)
Step 1
(8) 2 1/2" screws.
Attach the leg assemblies to the table top using
Lay the table top on a flat surface.
Step 2
Attach feet to legs using
(4) 2 1/2" Chair bolts (
Qty. Description
*Please note: umbrella support optional,
can be removed if necessary to fit
umbrella stand
4mm HEX KEY, ALLEN
(INCLUDED)
Set table upright and tighten all bolts
Step 4
TOOLS NEEDED
Step 3
Attach leg braces using
(4) 3" screws
Attach umbrella brace to
the leg braces using (2) 3" screws.
Install 1 1/2" bolt into threaded insert on
__(1) Table top
__(4) Leg
__(2) Foot
__(2) Brace
__(1) Umbrella Brace
ALL HARDWARE IS COATED STAINLESS STEEL UNLESS OTHERWISE SPECIFIED
12/17/2012
ASSEMBLY INSTRUCTIONS
D
D
D
D
A
D
Removable table plug
included in table.
D
C
C
B
/
