Repotec RP-VC111T Owner's manual

Repotec
Brand
Repotec
Model
RP-VC111T
Type
Owner's manual
RP-VC111T/RP-VC112T Quick Installation Guide V1.1
1
RP-VC111T/RP-VC112T Ethernet Extender
Front & Rear panel
Package Content
Main Unit x 2
RJ-45 Cable x 2
5V/1A Power Adapter x 2
Quick Installation Guide x 1
LED Indication Status
LED\Status OFF ON Flashing
PWR (Power) Power off Power on --
ETH (Ethernet) Disconnected Connected Traffic passing through
DSL (VDSL)
COAX (Coaxial)
-- Connected
Slow- Prepare for connection
Fast- Training or traffic passing through
Power LED
Ethernet Link LED
VDSL Link LED
Coaxial Link LED
RP-VC111T RP-VC112T
RP-VC111T RP-VC112T
1
RP-VC111T/RP-VC112T Quick Installation Guide V1.1
2
DIP switch
All settings are off by Default.
DIP1 DIP2 DIP3 DIP4
Functions CO/CPE mode Profile mode
Bandwidth SNR target
ON CPE 17a Symmetric 6dB
OFF CO 30a Asymmetric 9dB
Getting installation with the device
Step1. In order to pair the RP-VC111T/RP-VC112T, the DIP switch setting has to be set as one CO
and the other as CPE mode.
Step2. Please plug in the provided power adapter and connect a twisted pair with RJ-11 connecter
to the DSL port of RP-VC111T. (If coaxial cable is to be base infrastructure, RP-VC112T will be
placed.)
Step3. Connect RJ-45 cables to the LAN port from an IP camera or other Ethernet network devices
on LAN then observe the status of DSL link. (If RP-VC112T is installed, the LED status will be COAX
link.)
Step4. Once the DSL/COAX link is established, both RP-VC111T/RP-VC112T has been paired. You
can use RJ-45 cable to connect RP-VC111/RP-VC112 and your LAN network and then start to use
your network services.
❷
❹
❶
❶
❷
❸
RJ-45
RJ-45 Twisted Pair
Coaxial Cable
RP-VC111T
RP-VC112T
RP-VC111T
RP-VC112T
2
  • Page 1 1
  • Page 2 2

Repotec RP-VC111T Owner's manual

Repotec
Brand
Repotec
Model
RP-VC111T
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents