User Manual
Fill light tripod
Model: MLT04
- 01 -
Important Safety Instructions
1.
2.
3.
4.
5.
6.
Specifications
Using Your Tripod
To setup your tripod:
1.
2.
Make sure that all levels,handles,knobs and leg locks are correctly
tightened and that all three legs are fully opened before use.
Do not carry or transport the tripod with camera equipment
attached(for example:over your shoulder or cradled in your arms)
Do not store or expose your tripod to excessive heat or cold,or use
near any flame or fire.
Do not OIL or GREASE any part of the tripod.
Do not use any solvents or thinner to clean your tripod.Use only a mild
detergent and wipe dry with a soft,lint-free cloth only.
Do not exceed the load limit of this product.
Open the flip-lever leg locks on each leg and extend the legs to the
desired length.
Close the flip-lever leg locks to lock the leg at the selected length.
Caution: Not correctly securing a leg lock can cause the tripod leg to
retract unexpectedly and could result in damage to the tripod or a
camera mounted on the tripod.
Maximum Height:
Minimum Height:
Folded Length:
Weight:
Load Capacity:
55”(1.4m)
16”(0.41m)
16.7”(0.425m)
1.3lbs(0.59kg)
6.6lbs(3kg)
- 02 -
Tripod Components
1.
2.
3.
4.
5.
6.
7.
8.
9.
Platform
Pan locking knob
Locks the tripod head so that it will not rotate horizontally
Leg
Supports your tripod
Center column
Adjustable column provides a quick height adjustment
Leg braces
Provides stability to your tripod
Flip-lever leg locks
Lift to adjust leg height, then close to lock
Rubber feet
Provide secure,non-marring footing for your tripod
Tilt-locking handle
Turn counterclockwise to loosen the tripod head.Turn clockwise to
tighten the tripod head
Locking knob
Locks the center column in place
1
2
4
5
6
7
9
8
3
MLT01
- 03 -
12 Inch Ring Live Light
USB Power Source
Flexible Phone Holder: To
Controle Box:
ON/OFF, Control The Color
Ball head:Fixed on che lamp holder
DC Input Power:DCSV/2A(USB)
Ra: Ra 80
LED PCS: 162
Max Power: 10W
Luminous Flux: 4801m
Color Temperature : 3000-6500K
Weight: 324g
Luminance Control Mode:
Stepless Dimming
- 04 -
Wireless Bluetooth Remote Shutter
Steps:
1.
2.
3.
4.
Operating system
Bluetooth Communication
Frequency
Communication distance
Battery
Compatible with Android 4.2.2
or newer iOS 6.0 or newer
Bluetooth Version 3.0
2.4GHZ-2.4835GHz
10m30 feet
Button Cell Battery CR20323V
Remove the back cover of Bluetooth, put in the battery (make the positive
pole sife up) and install the battery.
Press the switch button on the left, the blue light keeps flashing
The blue light flashes to indicate that it can match the Bluetooth of your
mobile phone.
Turn on the Bluetooth of your mobile phone and match BT1818
Bluetooth. After the mobile phone is connected to BT1818 Bluetooth, you
can control the mobile phone to take pictures from a long distance by
briefly pressing the photo button once.
/
