Pyle PIDOCK1 Installation guide

PIWIPDK1

iPod/iPhone In-Wall Mounted Audio/Video Docking

Center w/Wireless Remote

http://www.pyleaudio.com

Installation Guide.

For the easiest possible installation, please read and follow these tips.

1. You’ll need two sets of wires for a full audio/video installation. Use Cat5 (Ethernet) cable for the

audio and power. For video, choose composite, or s-video, which will provide a higher quality

image. Run these two wires together between the dock and output box for your convenience.

2. For best results, do not use the Ethernet (RJ-45) jack on the output box. You should not crimp

RJ-45 connectors onto the Cat5 cable. Instead, separate the wires by color and use a Cat5 punch

down tool to individually connect each wire to the white connector. The order, from bottom to top,

is as follows: brown-stripe, brown, green-stripe, green, orange-stripe, orange, blue-stripe, blue.

This manual is also suitable for

Download PDF