Abocom GS400 User manual

Category
Network switches
Type
User manual

Abocom GS400 is a 4-port gigabit switch that provides high-speed network connectivity for your devices. It supports 10/100/1000Mbps speeds, and its auto-negotiation feature ensures that it will automatically adjust to the highest speed supported by your devices. The GS400 also supports full-duplex operation, which allows for simultaneous data transmission and reception.

With its four ports, the GS400 can be used to connect multiple devices to your network, such as computers, printers, and storage devices. It also supports VLANs (virtual LANs), which allow you to segment your network into multiple logical networks. This can be useful for separating different types of traffic, such as business and personal traffic, or for isolating devices that should not be able to communicate with each other.

Abocom GS400 is a 4-port gigabit switch that provides high-speed network connectivity for your devices. It supports 10/100/1000Mbps speeds, and its auto-negotiation feature ensures that it will automatically adjust to the highest speed supported by your devices. The GS400 also supports full-duplex operation, which allows for simultaneous data transmission and reception.

With its four ports, the GS400 can be used to connect multiple devices to your network, such as computers, printers, and storage devices. It also supports VLANs (virtual LANs), which allow you to segment your network into multiple logical networks. This can be useful for separating different types of traffic, such as business and personal traffic, or for isolating devices that should not be able to communicate with each other.

4-Port Gigabit Switch
In today’s enterprise environments that require more advanced
processing, the GS400 4-port gigabit switch is the best
switching hub solution for the backbone of networks handling
high capacity data and multimedia data.
The GS400 complies with IEEE 802.3 10Base-T, IEEE 802.3u
100Base-TX, IEEE 802.3ab 1000Base-T and IEEE 802.3x
flow control, providing users four ports with auto-negotiation
function, which can automatically adjust device speeds at
10/100/1000Mbps for optimum operation; “Store-and-
Forward” architecture filters to eliminate error packets and
improve efficiency. Plus, based on Auto-MDI/MDIX
technology, just use either a straight through or a crossover
Ethernet cable, and you can get connected with any other
devices.
Equipped with Classes of Service (CoS) and 4 port-based
VLAN that enables control over packet transfers thorough
prioritization of data traffic, the GS400 enables flexible
network configuration and raises network application
availabilities of groupware, databases and so on. All of these
expand the range of possibilities on network.
FEATURES
Four 10/100/1000Mbps auto-sensing Ethernet ports
Complies with IEEE 802.3 10Base-T, IEEE 802.3u
100Base-TX and IEEE 802.3ab 1000Base-T standards
“Store and Forward” architecture
IEEE 802.3x or Back Pressure (HDX) Flow Control
Full Aggregate Bandwidth up to 8 Gbps.
8K MAC Address table supported
Four Classes of Service (CoS) selectable per port basis
and/or checked via IP header and 802.1Q VLAN Tag
Support 4 port-based VLANs
Configurable to 10 full/half duplex, 100 full/half
duplex and 1000 full duplex for each port
Broadcast throttling
Port Mirroring for debugging network problems
Support on a RS-232C console port for switch
configuration change.
Built in Universal Power Supply: 100~240V
Emission certification: FCC Class A, CE
SPECIFICATIONS
Standards
IEEE 802.3 10Base-T Ethernet
IEEE 802.3u 100Base-TX Fast Ethernet
IEEE 802.3ab 1000Base-T Gigabit Ethernet
IEEE802.3x Flow Control
Access Method CSMA/CD
Ports Four 10/100/1000Mbps RJ-45 Ports; Supporting Auto-MDI/MDIX
Console port One female RS-232C D-sub 9 pin for configuration change
Cabling type UTP Category 3 or better for 10Base-T
UTP Category 5 or better for 100Base-TX
Enhanced Cate
g
or
y
5 cables
,
Cate
g
or
y
6 cables for 1000Base-T
Data Transfer Rate Ethernet 10Mbps in Half-duplex, 20Mbps in Full-duplex
Fast Ethernet 100Mbps in Half-duplex, 200Mbps in Full-duplex
Gi
g
abit Ethernet 2000Mb
p
s in Full-du
p
lex
Switching Scheme Store-and-Forward
Flow control Full Duplex: IEEE 802.3x
Half Duplex: Back Pressure
MAC Address Table 8K, with Searching, Self-learning, Automatic aging
VLAN Port-based VLAN, 4 groups
CoS (Class of Service) Port-based, 4 groups
LED indicators Power Green
LINK/ACT Green: 1000Mbps, Orange: 10/100Mbps
FDX/HDX Green: Full-du
p
lex
,
Oran
g
e: Half-du
p
lex
Physical Dimension 273 x 161 x 45mm3 (Width x Depth x Height)
Weight 1.2 Kg
Power Consumption 14W
Power Input AC 100~240V, 50~60Hz
Agency and Regulatory FCC Class A, CE
Operating Temperature 0°C to 50°C
Operating Humidity 5~95% non-condensing
  • Page 1 1

Abocom GS400 User manual

Category
Network switches
Type
User manual

Abocom GS400 is a 4-port gigabit switch that provides high-speed network connectivity for your devices. It supports 10/100/1000Mbps speeds, and its auto-negotiation feature ensures that it will automatically adjust to the highest speed supported by your devices. The GS400 also supports full-duplex operation, which allows for simultaneous data transmission and reception.

With its four ports, the GS400 can be used to connect multiple devices to your network, such as computers, printers, and storage devices. It also supports VLANs (virtual LANs), which allow you to segment your network into multiple logical networks. This can be useful for separating different types of traffic, such as business and personal traffic, or for isolating devices that should not be able to communicate with each other.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI