INTRODUCTION
How to use this manual
The windows in this reference are meant to simulate the
windows that appear on your PC UI screen. Use this reference
to find information on the function of a particular window, or the
type of information that should be entered in a field.
To locate information on a particular window, look up the name
of the window (upper left corner of window) in either the table
of contents or the index.
Underneath each figure is a description of the window functions,
as well as the parameters that are displayed in the window, and
any notes or hints that relate to the task.
Conventions and symbols
The following conventions are used in this manual:
• Icons for warning, caution, and so on.
• The names of keys on the PC UI are depicted inside angle
brackets and capitalized, for example, the <ALT> key.
Figure headings
A numbered figure heading above each window shows the name
of the window and the pathway to get to that window.
Figure I-2. Disks>Reallocate>Print File Data window
For example, in the figure heading above, the name of the
displayed window is the Print File Data window. If your PC UI
screen was at the desktop window, to get to the Print File Data
window you would first select the Disks icon, then select the
Reallocate option, and finally the Print File Data option. To
return to the PC UI desktop, you would close all open windows.
Defaults
If you do not specify an option or value, one may automatically
be selected by the PC UI software. This automatically-selected
option is the default. In this manual, where applicable, system
defaults are underlined
.
For example:
Device: All Disks
, DP0, DP1, DP2, DP3, TD0, TD1, TD2.
Select/enter the system disk or tape reference.
In this example, unless you specify another system disk or tape
device, the system will automatically default to the All Disks
option.
xiv XEROX 4635 LASER PRINTING SYSTEM PC USER INTERFACE REFERENCE
