Altronix ALTV2432 Series Installation guide

Altronix
Brand
Altronix
Model
ALTV2432 Series
Category
Power extensions
Type
Installation guide
ALTV2432 Series
CCTV Power Supplies
Installation Guide
Models Include:
• ALTV2432 • ALTV2432CB
- 24VAC @ 8 amp (200VA) - 24VAC @ 8 amp (200VA)
- Thirty-two (32) Fuse Protected Outputs. - Thirty-two (32) PTC Protected Outputs.
• ALTV2432350 • ALTV2432350CB
- 24VAC @ 14 amp (350VA) - 24VAC @ 14 amp (350VA)
or 28VAC @ 12.5 amp (350VA). or 28VAC @ 12.5 amp (350VA).
- Thirty-two (32) Fuse Protected Outputs. - Thirty-two (32) PTC Protected Outputs.
• ALTV2432600 • ALTV2432600CB
- 24VAC @ 28 amp (700VA) - 24VAC @ 28 amp (700VA)
or 28VAC @ 25 amp (700VA). or 28VAC @ 25 amp (700VA).
- Thirty-two (32) Fuse Protected Outputs. - Thirty-two (32) PTC Protected Outputs.
Rev. 021704
Overview:
These Altronix CCTV Power Supplies provide 24VAC/28VAC distributed via thirty-two (32) fuse or PTC protected
outputs for powering CCTV Cameras, heaters and other video accessories.
Thirty-two (32) Output ALTV2432 Reference Chart:
ALTV2432 24VAC 8 amp 32 - x 3.5 amp 2.9 amp
ALTV2432CB 24VAC 8 amp 32 x - 2.5 amp 2.9 amp
ALTV2432350
24VAC 14 amp
32 - x 3.5 amp 2.7 amp
28VAC 12.5 amp
ALTV2432350CB
24VAC 14 amp
32 x - 2.5 amp 2.7 amp
28VAC 12.5 amp
ALTV2432600
24VAC 28 amp
32 - x 3.5 amp 5.4 amp
28VAC 25 amp
ALTV2432600CB
24VAC 28 amp
32 x - 2.5 amp 5.4 amp
28VAC 25 amp
Specifications:
Installation Instructions:
1. Mount unit in desired location.
2. Turn OFF main switch on unit
(Figs. 1-3, pgs. 4-6).
3. All units are factory set for 24VAC operation.
F
or 28V
A
C operation (where available) adjust unit prior to mounting and applying power as follows: Change the wire
position so that the b
lack wire [28V] is connected to the ter
minal mark
ed [P] and the y
ello
w wire [24V] is connected
to the terminal marked [S]
.
4. Connect AC power to the black and white flying leads of the transformer(s) (Figs. 1-3, pgs. 4-6), secure green lead to
earth ground. Use 18 AWG or larger for all power connections.
5. Measure output voltage before connecting devices. This helps avoid potential damage.
CAUTION: Determine the maximum operating voltage of the equipment being powered before adjusting
the output v
oltage.
6. Connect devices to terminals marked [1P - 1N through 16P - 16N] on PD16W/PD16WCB board
(Figs. 1-3, pgs. 4-6
),
carefull
y obser
ving polarity
.
Terminals marked [1P - 16P] are of the same polarity.
7. Turn main switch on unit to the ON (RESET) position
(Figs. 1-3, pgs. 4-6).
8. Green LED(s) will illuminate when unit is powered.
- 2 -
Altronix
Model Number
Output Current
(max per output)
Total Output Current
(Power)
Output Voltage
115VAC
50/60Hz Input
Current
Fuse Protected
Outputs
Number of
Outputs
• Surge suppression.
• AC power LED indicator.
• Power ON/OFF switch / circuit-breaker.
•
Unit maintains camera synchronization.
• Ease of installation saves time & eliminates costly labor.
• Spare fuses included (on fuse protected models).
Enclosure Dimensions:
13"H x 13.5"W x 3.25"D
PTC Protected Outputs
(Class 2 power limited)
- 3 -
9. Upon completion of wiring, secure enclosure door with screws (supplied).
Caution:
Equipment to be installed / serviced by authorized / trained personnel only.
Shut br
anch circuit power before installing / servicing equipment.
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or moisture.
This installation should be made by qualified service personnel and should conform to all local codes
and in accordance with the National Electrical Code. Use 75 C or higher rated UL insulated wiring for
connecting the unit to the mains.
Terminal Identification:
PD16W - Power Distribution Module
1P - 16P AC output.
1N - 16N AC output.
- 3 -
- 4 -
Fig. 1
ALTV2432 • ALTV2432CB
White
Lead
P
ower
Switch
Black
Lead
115VAC input,
5
0/60 Hz.
U
sed on PTC Models
(
example: ALTV2432CB)
Green
L
ead
(Ground)
Connected
t
o Door
3
.5A 250V
For continuous protection against risk of fire
r
eplace fuses with same type and rating.
c
ommon
outputs
protected
o
utputs
P
N
NPS
XFMR Input
PD16W
1
2345678
9 10 11 12 13 14 15 16
3.5A 250V
For continuous protection against risk of fire
replace fuses with same type and rating.
common
outputs
p
rotected
outputs
P
N
NPS
XFMR Input
PD16W
12345678
9 10 11 12 13 14 15 16
P
N
PTC’s
Power Distribution Module
NPS
XFM R Inp u t
PD16W
c
ommon
o
utputs
p
rotected
o
utputs
12345678
9 10 11 12 13 14 15 16
P
N
N
P
P
N
XFMR
XFMR
24VAC fused or PTC
protected outputs
1 through 16.
Input:
24VAC
operation.
Terminal Blocks for Fig. 1
- 5 -
Fig. 2
ALTV2432350 • ALTV2432350CB
Black Lead
W
hite Lead
1
15VAC input
50/60 Hz,
Used on PTC Models
(example: ALTV2432350CB)
X
FMR*
Green
Lead
(Ground)
Connected
to Door
3.5A 250V
For continuous protection against risk of fire 
r
eplace fuses with same type and rating.
common
outputs
p
rotected
outputs
P
N
NPS
XFMR Input
PD16W
12345678
9 10 11 12 13 14 15 16
P
N
PTC’s
Power Distribution Module
NPS
XFM R Inp u t
PD16W
common
outputs
protected
outputs
12345678
9 10 11 12 13 14 15 16
3.5A 250V
For continuous protection against risk of fire 
replace fuses with same type and rating.
common
outputs
protected
o
utputs
P
N
NPS
XFMR Input
PD16W
12345678
9 10 11 12 13 14 15 16
N
P
P
N
P
N
Power Switch
24VAC or 28VAC
fused or PTC protected outputs
1 through 16.
Input:
24VAC or
28VAC
operation.
Terminal Blocks for Fig. 2
- 6 -
White
Lead
P
ower
S
witch
XFMR*
Black
Lead
1
15VAC input,
5
0/60 Hz.
Used on PTC Models
(example: ALTV2432600CB)
XFMR*
Green
Lead
(Ground)
Connected
to Door
3.5A 250V
F
or continuous protection against risk of fire 
r
eplace fuses with same type and rating.
common
outputs
p
rotected
outputs
P
N
NPS
XFMR Input
PD16W
12345678
9 10 11 12 13 14 15 16
3.5A 250V
For continuous protection against risk of fire 
r
eplace fuses with same type and rating.
common
outputs
protected
o
utputs
P
N
NPS
XFMR Input
P
D16W
12345678
9
10 11 12 13 14 15 16
P
N
PTC’s
Power Distribution Module
NPS
XFM R Inp u t
PD16W
common
outputs
protected
outputs
12345678
9 10 11 12 13 14 15 16
P
N
N
P
P
N
Fig. 3
ALTV2432600 • ALTV2432600CB
24VAC or 28VAC
fused or PTC protected outputs
1 through 16.
Input:
24VAC or
28VAC
operation.
Terminal Blocks for Fig. 3
- 7 -
00
0
.81"
0
1.1875"
1.1875"
3.25"
3.25"
0 1.1875" 3.25".75" 1.5" 6.25" 11"
1.4"
6.5"
5.5"
1.4"
11.66"
12.1"
13"
12.5"
11.75"
TOP ONLY
Enclosure Dimensions:
13"H x 13.5"W x 3.5"D
- 8 -
Altronix Corp.
140 58th Street, Brooklyn, Ne
w
York 11220 USA, 718-567-8181, fax: 718-567-9056
web site: www.altronix.com, e-mail: [email protected], Lifetime
W
ar
ranty
, Made in U.S.A.
IIALTV2432Series H16D
MEMBER
Altronix is not responsible for any typographical errors.
Notes:
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Altronix ALTV2432 Series Installation guide

Altronix
Brand
Altronix
Model
ALTV2432 Series
Category
Power extensions
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents