Page is loading ...
Printed in Taiwan
133-07-188-3A
RACK MOUNTING BRACKET KIT
INSTRUCTION MANUAL
MB-WT1
MB-WT2
Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
1. GENERAL DESCRIPTION
These kits are used exclusively to mount a unit of 210 mm wide in an EIA Standard equipment
rack. The MB-WT1 is for mounting one unit, and the MB-WT2 for mounting two units.
4. SPECIFICATIONS
3. HOW TO USE
2. PARTS MAKING UP THE KIT
Note: The design and specifications are subject to change without notice for improvement.
Step 1. Insert the bracket along the
unit's guide rail till it stops.
Step 2. Similarly, mount the connector
to the unit.
Step 3. Align the mounting box* guide
rail with the mounted connector,
then push in the mounting box*
till it stops as shown in the
figure.
* Supplied with the MB-WT1.
Read the "mounting box" as
"unit" when the MB-WT2 is
used.
Step 4. Mount another bracket to the
mounting box.
Step 5. Mount the connected units in
the rack using the supplied
screws.
Caution
The supplied rack mounting
screws are special screws for
the TOA equipment rack.
They cannot be used for some
other racks.
1
2
3
4 5
1
2
3
4
5
Bracket ............................. 2
Connector ......................... 1
Mounting box .................... 1
Rack mounting screw ....... 4
Fiber washer ..................... 4
1
2
3
4
Bracket ............................. 2
Connector ......................... 1
Rack mounting screw ....... 4
Fiber washer ..................... 4
1
2
3 4
MB-WT1 MB-WT2
2
1
Bracket
Connector
Unit (optional)
4
3
Mounting box
(or unit when MB-WT2
is used)
Bracket
Fiber washer
Rack mounting screw
Rack
MB-WT1 MB-WT2
Bracket, connector: POM resin Bracket, connector: POM resin
Mounting box: ABS resin
Model No.
Finish
/
