Fishman Fishman Isys III User manual

Brand: Fishman

Model: Fishman Isys III

Type: User manual

USER GUIDE

ISYS III ONBOARD PREAMP

www.ﬁshman.com

2 3

Isys III Quick Start

1. Set the controls • Set volume off and bass, middle and treble to center.

2. Plug in • Connect the Isys III to an ampliﬁ er or PA with a ¼-inch instrument

cable. The batt light will ﬂ ash once quickly to indicate it has switched on.

3. Tune up • Press the tuner button. When it’s on, the tuner mutes the

signal. Press again to exit.

4. Turn up • Raise the volume and adjust the bass and treble controls to your

liking.

Isys III Controls

Volume • For the cleanest signal, set the volume knob as high as possible,

without causing distortion or feedback.

Bass • Boost here to add depth and weight to the sound of the guitar.

Middle • Turn the middle knob all the way left for a smooth “scooped out”

tone at high volume levels. Raise the middle knob to the right of center to add

midrange “bite” to the sound.

Treble • Boost to cut through the mix. Cut to mellow and subdue the sound.

Tune • Use the tuner lights as shown below to tune your instrument.

When the batt lamp lights steadily it is time to change the battery. To conserve

the battery, unplug the instrument and turn off the tuner when not in use.

“A” note

below pitch

“A” note

in tune

“A” note

above pitch

“A#” note

in tune

www.ﬁ shman.com

513-300-163 Rev C 2-11

FCC COMPLIANCE NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and if not used in accordance with the instructions, may cause harmful

interference to radio communications and there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television recep-

tion, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures: reorient or relocate the receiving

antenna, increase the separation between the equipment and receiver, connect the equipment into

an outlet on a circuit different from that of the receiver. Consult the dealer or an experienced radio/TV

technician if help is needed with interference.

NOTE: FMIC and Fishman Transducers, Inc. are not responsible for unauthorized equipment

modiﬁ cations that could violate FCC rules, and/ or void product safety certiﬁ cations.

Fishman Fishman Isys III User manual

Fishman Fishman Isys III User manual

Fishman Fishman Isys III User manual

Related papers

Other documents