2. Pentair Pool
  3. Battery

Pentair Pool Battery Owner's manual

  • Hello! I've reviewed the battery replacement instructions for the Pentair IntelliCenter 522978Z indoor control panel. This document provides clear steps on how to safely remove the old battery and install a new one, including important safety precautions and disposal information. I'm here to assist with any questions you have about this process or the device itself.
  • What should I do before starting the battery replacement?
    How do I remove the old battery from the control panel?
    How should I dispose of the old lithium battery?
INTELLICENTER® CONTROL SYSTEM
BATTERY REPLACEMENT KIT INSTRUCTIONS FOR INDOOR CONTROL PANEL (P/N 522978Z)
Battery Removal
1. TURN OFF POWER TO ALL POOL AND SPA EQUIPMENT BEFORE STARTING.
2. Carefully pull and un-snap the front part of the Indoor Control Panel from
the back plate mounted on the wall.
3.  Placethecontrolpanelfacedownonacleanatsurface.
4. Press the tab on the 2-wire battery connector and pull upward to release
the connector from the circuit board.
5.  Whileholdingthebatterywithyourngers,pressthefrontbatterytab
and pull upward to release the battery from the two rear retaining tabs.
IMPORTANT! LITHIUM BATTERY DISPOSAL: Please dispose of the Wireless Remote lithium battery at your local battery recycling facility as required by your
local and state regulation. DO NOT dispose of the lithium battery in your garbage or recycling containers.
Rear tabs
Front tab
Battery wire connector
Battery Front tab slot
Wire Connector
Front tab
Wall mounted
back plate
1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000 - 10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000
P/N 523484.A 7/2019 - Pentair Water Pool and Spa, Inc. Technical Support (800) 831-7133 - www.pentair.com
Battery Installation
1. Insert the two rear battery tabs into the circuit board slots. Press down to engage the front locking tab and secure the battery in place.
2. Insert the 2-wire battery connector into the circuit board socket.
3. Align the panel front part with the mounted back plate and press the front part on to the back plate to snap-in-place.
/