Manual Trike tentP. 1
800063H
Front panel
0. Overview of the parts.
Bow (2x)
1.
3.5 x 9.5 screw + press stud (4x)
Elastic (4x)
3.
5.
M6 x 30 bolt + nuts (8x)
2.
4.8 x 18 screw + cylinder (4x)
Tent
4.
6.
Mount the assembled bow in the box by
pressing the bow together and snapping it
in the four holes on the side of the box. Re-
peat this step for the other side.
Step 2. Pre-assembly left panel
Put the bolts and nuts (2) in the bows (1)
make sure the nuts are facing outwards.
Step 1. Assemble the bows
2.
1.
3.
4.
5.
6.
Take note that: when you are mounting the tent on a narrow trike the tent uses two seperate
bows (1), the small bow needs to be placed in the front of the box.
Manual Trike tentP. 2
800063H
Put the tent (6) over the bows (1) and close
the zippers of the tent. Make sure the notch
in the tent is alligned with the steering tube.
Step 3. Put the tent over
Mount the four elastics (5) on the tent.
Step 4. Mount the elastics on the tent
Allign the press stud with the stud on the
box and mark the position. Now mount the
press stud with the included screws. Repeat
this step for al four sides of the tent.
Mount the cylinder (4) on the front and the
back of the box with screws. Make sure there
is enough tension on the elastics to keep the
tent in the correct form.
Step 6. Mount the press studsStep 5. Mount the cillinders
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Fleetwood 2005 Cheyenne Owner's manual
-
SunnyTent OVAL User manual
-
M and M Sales Enterprises MM00173 User manual
-
Anchor ETI 30’CLASSIC FRAME TENTS Assembly Instructions Manual
-
-
Sea Ray 1988 PACHANGA 19 Owner's manual
-
Gazelle 26800 User manual
-
Clam Corp Camping Equipment 8202 User manual
-
-
