American Standard 0291.004 User manual

Type
User manual

This manual is also suitable for

J31
BARRIER FREE
© 2008 AS America Inc.
400mm
(15-3/4")
457mm
(18")
584mm
(23")
203mm
(8")
FINISHED FLOOR
*
254mm
(10")
*
295mm
(11-5/8")
19mm
(3/4")
197mm
(7-3/4")
OPTIONAL
224mm
(8-7/8")
SUPPLIES
AS REQ'D
203mm
(8")
FINISHED WALL
OR SPLASHBACK
1-1/4 O.D.
WASTE
1-3/4" DIA.
STD. DRAIN
OUTLET
1-1/4" O.D.
TAILPIECE
SEALING COMPOUND
(BY OTHERS)
COUNTERTOP
(BY OTHERS)
3 Holes
1-3/8" (35mm) Dia.
178mm
(7")
787mm (31)
845mm (33-1/4)
845mm
(33-1/4)
51mm
(2)
610mm
(24)
152mm
(6)
MAX.
BARRIER FREE
CLEARANCE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
DRAWING FOR
DIMENSIONAL
PURPOSES ONLY.
IT IS NOT AN EXACT
REPRESENTATION.
RETROSPECT COLLECTION
®
COUNTERTOP SINK
FINE FIRECLAY
RETROSPECT COLLECTION
®
COUNTERTOP SINK
Classically-styled countertop sink
Retrots in any 20" x 17" cutout
Made from reclay china
Front overow
Self-rimming with cutout template supplied
Part of design matched Retrospect Collection
®
0291.004 Faucet holes on 4" (203mm) centers
0291.008 Faucet holes on 8" (102mm) centers
(illustrated)
Nominal Dimensions:
584 x 457mm
(23" x 18")
Bowl sizes:
422mm (16-5/8") wide
286mm (11-1/4") front to back
159mm (6-1/2") deep
Compliance Specications -
Meets or Exceeds the
Following Specications:
• ASME A112.19.9M for
Non-Vitreous Ceramic Fixtures
• CAN/CSA B45 Series
MEETS THE AMERICAN DISABILITIES ACT GUIDELINES AND
ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND
FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from nished oor.
Lavatory installed 51mm (2") minimum from front edge of countertop
provides 686mm (27") knee clearance area.
To Be Specied:
Color: White only
Recommended Faucet: 2373.701
Faucet Finish:
Supplies:
1-1/4" Trap
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP
ARE SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
Revised 5/06
  • Page 1 1

American Standard 0291.004 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI