2. Vehicles & accessories
  3. Motor vehicle electronics
  4. Havis-Shields
  5. C-TM-IMP

Havis-Shields C-TM-IMP User manual

  • Hello! I am an AI chatbot trained to assist you with the Havis-Shields C-TM-IMP User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TRAK-MOUNT ASSEMBLY
(Image Upside down)
INSTALL INSTRUCTIONS C-TM-IMP
2000-2005 CHEVROLET IMPALA TRAK-MOUNT KIT
TOOLS REQUIRED:
Ratcheting Wrench
Metric Socket Set
Torx Bit Set
Standard Socket Set
Tape Measure
HARDWARE:
QTY DESCRIPTION PART#
8 ¼” x ¾” hex head bolt GSM33001
8 ¼” Serrated nut GSM30023
6 ¼” x 1” Hex head lag bolts GSM33060
1 32” Trak mount CM93055-9
SUB ASSEMBLY:
1. MOUNT TRAK TO HUMP BRACKETS.
• Determine location that Trak will land on transmission hump for the specific
application.
• With Trak in necessary location, measure Front and Rear Hump Brackets in relation
to Trak.
• Bolt Trak to Hump Brackets, using measurements taken in previous step
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets
to side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment,
(consoles, control heads, etc)
• Slide (6) ¼-20 x ¾” Hex Head Bolts into ¼” Hardware Slots.
• With bolts in Trak, position Hump brackets.
• There is a left and right side to the Rear Hump Brackets. Top of brackets will be
parallel to the transmission hump.
• Attach ¼” serrated nuts and tighten.
Front Hump Bracket C-B17
Rear Hump Bracket C-B27
Trak
¼” Hardware Slots
C-TM-IMP-INST-2-07
2
INSTALLATION:
1. REMOVE SEATS:
• Remove rear seat base torx bolts.
• Slide seat to rear most position.
• Seats do not have to come out of vehicle, they will just need to be tilted out of way to
place Trak-Mount assembly. Be careful of wire plugs if vehicle has power seats.
2. MOUNT ASSEMBLED TRAK-MOUNT:
• Place Trak-Mount assembly so front bracket sets squarely on floor beam straddling
seat bolts – lag bolt to the floor beam. The rear hump brackets are place on floor
between floor of vehicle and seat base and can be mounted using the rear seat bolts.
• Re-mount seats over Trak-Mount assembly and tighten all hardware.
• Mount equipment (consoles, control heads, etc), prior to plastic end caps, for access
to hardware slots.
Rear Hump Bracket
(Driver Side)
Rear Hump Bracket
(Pass. Side)
Front Hump Bracket
Trak
/