Scotsman KBT14A - Use with a 42" wide modular cuber, modular nugget, or flaked ice machines onto a 48" wide bin Operating instructions

Model: KBT14A - Use with a 42" wide modular cuber, modular nugget, or flaked ice machines onto a 48" wide bin

KBT14A - fits a variety of ice storage bins and ice machines.

Kit contents:

• 2 filler plates

• Tube of sealant

• Support brackets

To Install:

1. Remove 7 inches of gasket from each end of the bin.

2. Lay a bead of sealant in the area where the gasket was removed.

3. Place one bin top

panel on each end of

the bin and push

down to seat the

panel. The insulated side of

the panel faces down.

4. Place ice machine on

bin.

5. Fasten ice machine to bin using the support brackets from the kit and the hardware

from the ice machine.

A32871-001 Rev B.

Instructions

Remove gasket in shaded

areas, then apply sealant.

Gasket

Model: KBT14A - Use with a 42" wide modular cuber, modular nugget, or flaked ice machines onto a 48" wide bin