Intellinet RJ45 Repair Clip User guide

Intellinet
Brand
Intellinet
Model
RJ45 Repair Clip
Type
User guide

This manual is also suitable for

Block is suitable for
broken latch
Repair a damaged plug
Damaged plug
RJ45 Repair
Block
If STP Plug bottom is too thick
Placing a repair block over the lip and
Other situations
too short too long
Assembly
(A)
inserting into a jack will cause a jam.
Finished
(B) (C)
Block is not suitable
for cleaned latch
proper length
Repair a damaged plug quickly & easily
1. Use a cutting tool (or your ngers) to partially remove the existing latch on the
cable's plug; leave a 1-mm lip. (Note: breaking the existing latch at too short or too long
a length will make for a poor connection that could either jam or incorrectly t your
cable jack [see diagram below]).
2. If color-coding your cables, choose a repair block that matches the cable you want to
repair. If not, select a block from the container.
3. Place the repair block over the base of the plug. If necessary, slide the top of the new
clip under the 1-mm lip you cut. Installation is complete.
Instructions
Quick Install Guide
INT-771436-771443-771450-QiG-0316-5.01
www.intellinet-network.com
Compliance Specication:
°RoHS
°REACH
Lifetime Warranty
  • Page 1 1

Intellinet RJ45 Repair Clip User guide

Intellinet
Brand
Intellinet
Model
RJ45 Repair Clip
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents