FMI DAVDBK Operating instructions

FMI
Brand
FMI
Model
DAVDBK
Category
Fireplaces
Type
Operating instructions
installation instructions
For BloWEr Kit MoDEl DaVDBK
WARNING: Disconnect all electrical power to the


1. To remove lower louver, pull both top spring latches toward
the center of the appliance at the same time until they are
disengaged from the locating holes. Repeat for bottom spring
latches and pull louver outward.
2. Place blower assembly so it rests ush against the inside
wallontheueexitsideoftherebox(seeFigure1).There
are four magnets on the bottom of the blower assembly that
willkeeptheblowerinplaceonreboxbottom.Note: If the
blowerkitisnotinstalledushagainsttheinsidesidewallof
thereplace,thecirculatingairfromtheblowersystemwill
notowproperly.

1. To operate blower, turn the blower speed control knob
clockwisetotheONposition(seeFigure3).Thiswillbe
the highest blower speed. Continue turning knob clockwise
toreduceblowerspeed.Turnknobonlywithinthespecied
range(1/4revolution,seeFigure3).
2. To turn blower off, turn blower speed control knob counter-
clockwiseuntilitclicksintotheOFFposition.Youmustturn
until knob clicks for the unit to be completely off.
Figure 1 - Blower Assembly Placement
Blower
Assembly

Figure 2 - Blower Speed Control Location
Glass
Speed
Control
Spring Latch
BLOWER
SPEED
CONTROL
BLOWER
ASSEMBLY
BLK (16 ga.)
BLK (16 ga.)
Wire Connectors 3 Places
Figure 4 - Wiring Diagram for Blower Assembly
Magnet
High Speed ON/OFF
Low
Speed
Magnets
1/4 Revolution
105805-01
55816
Rev. B
02/06
2701 Industrial Drive
PO Box 90004
Bowling Green, KY 42102-9004
NOT A UPC
Figure 3 - Blower Speed Control
Blower Center to
Firebox Bottom
Center Along Inside
Wall by Flue Exit
Peninsula or See-Thru
Fireplace Installed
Flue
Exit

105805 01
Inside
Wall

1. Place speed control switch assembly on the bottom of the inside of
therebox(seeFigure2).Theassemblyisequippedwithmagnets
ontheleftandrighttoproperlyanchorittotherebox.
2. Plug blower with speed control assembly into a power source.
Keep hands clear of fan when running.
®
  • Page 1 1

FMI DAVDBK Operating instructions

FMI
Brand
FMI
Model
DAVDBK
Category
Fireplaces
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents