2. Meyer Sound
  3. USW-210P

Meyer Sound USW-210P Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Meyer Sound USW-210P Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
USW-210P RAIN HOOD INSTALLATION
1
Meyer Sound Laboratories Inc.
2832 San Pablo Avenue
Berkeley, CA 94702
www.meyersound.com
Tel: +1 510 486.1166
Fax: +1 510 486.8356
Copyright © 2018
Meyer Sound Laboratories Inc.
05.268.035.02 A2
If you are planning to use the USW-210P outdoors, a rain hood must be installed to ensure the loudspeaker’s electronics are shielded
from the elements. The USW-210P with the rain hood installed can only be used in its horizontal orientation.
If mounted using the USW-210P MUB Kit, the maximum amount of downtilt recommended to ensure full weather protection is 20
degrees.
Figure 1 Orientation of the rain hood and tilt angle limitation of the USW-210P speaker with rain hood option.
INSTALLING THE USW-210P RAIN HOOD
To install the USW-210P horizontal rain hood:
1. Attach any required cables to the USW-210P and then orient the loudspeaker horizontally.
2. Carefully fit the rain hood over the USW-210P rear panel so the screw holes are aligned.
3. Insert the four screws and tighten them. Recommended torque value for screws is 10–12 in-lbs (1.1–1.4 N-m).
/