Meyer Sound USW-210P Installation guide

USW-210P RAIN HOOD INSTALLATION

Meyer Sound Laboratories Inc.

2832 San Pablo Avenue

Berkeley, CA 94702

www.meyersound.com

Tel: +1 510 486.1166

Fax: +1 510 486.8356

Meyer Sound Laboratories Inc.

05.268.035.02 A2

If you are planning to use the USW-210P outdoors, a rain hood must be installed to ensure the loudspeaker’s electronics are shielded

from the elements. The USW-210P with the rain hood installed can only be used in its horizontal orientation.

If mounted using the USW-210P MUB Kit, the maximum amount of downtilt recommended to ensure full weather protection is 20

degrees.

Figure 1 Orientation of the rain hood and tilt angle limitation of the USW-210P speaker with rain hood option.

INSTALLING THE USW-210P RAIN HOOD

To install the USW-210P horizontal rain hood:

1. Attach any required cables to the USW-210P and then orient the loudspeaker horizontally.

2. Carefully ﬁt the rain hood over the USW-210P rear panel so the screw holes are aligned.

3. Insert the four screws and tighten them. Recommended torque value for screws is 10–12 in-lbs (1.1–1.4 N-m).