INSTRUCTION MANUAL
Product images may vary slightly from actual product.
Ceiling Fan LED Universal Light Fixture Kit
Page is loading ...
TABLE OF CONTENTS
SAFETY RULES .................................................................4
PACKAGE CONTENTS ....................................................5
INSTALLING THE LIGHT KIT .....................................6-7
INSTALLING THE LAMPS & GLASS SHADE ..........8
FCC WARNING ....................................................................9
3
Ceiling Fan LED Universal Light Fixture Kit |
SAFETY RULES
WARNING! RISK OF ELECTRIC SHOCK
All electrical connections must be made in accordance with local codes, ordinances, or national codes. If you are unfamiliar with
installing electrical wiring, secure the services of a qualified electrician. Before starting this installation, disconnect the power by
turning o the circuit breaker at your main panel or removing the fuse at the fuse block. Turning the power o using the ceiling fan
switch (speed control on/o) is not sucient to prevent electrical shock.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common sense, caution and care are factors which cannot be built into any
product. These factors must be supplied by the person (s) caring for and operating the unit.
SPECIAL NOTICE: This appliance is equipped with a “Wattage Limiting Device” required by the United States Department of
Energy. The device has been installed at the factory and can not be removed.
Installing Lamps in excess of 75 total watts will disable the units light fixture. If this should happen, you will need to reset the
lighting fixture by turning the power o to the ceiling fan and/or light fixture, reinstalling lamps totaling less that 75 watts and then
turning the power back on.
“CAUTION-RISK OF FIRE”
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR.
4 | KICHLER.COM
PACKAGE CONTENTS
Unpack your light fixture and check the contents.
You should have the following items:
a. Light Fixture
b. Glass Shade
c. (2) 9 Watt E26 LED lamps
d. Part bag contents:
Nut
Spring Washer
Pull Chain and Fob
(2) Wire Nuts
c
d
b
a
5
Ceiling Fan LED Universal Light Fixture Kit |
INSTALLING THE LIGHT FIXTURE KIT
1. Remove and discard the center plug from the switch housing. Attach the
light kit to the switch housing by feeding the light kit wires (black and white)
through the hole in the center of the switch housing, then screw the light kit
onto the switch housing.
Attach the nut & lock washer on the inside of the switch housing making sure
the light kit is secure to prevent movement after installation. (Fig. 1)
2. Locate the white and blue wires inside the switch housing labeled FOR LIGHT.
3. Attach the wires from the light kit to the wires inside the switch housing by
pushing the polarized connections together.
- White wire to White wire
- Black wire to Black (Blue) wire
Fig. 1
Switch
housing
Center
plug
Lock washer
Nut
Light fixture kit
6 | KICHLER.COM
INSTALLING THE LIGHT FIXTURE KIT
4. Raise and hold the light kit assembly close to the mounting plate of
the ceiling fan. Push the square wire connectors together. (Fig. 2)
NOTE: The square connectors are color coded. Match the color coded
sides of each plug and push. They will attach ONLY when matched
correctly.
5. Carefully push all wires back into the switch housing, then install the
light kit assembly onto the mounting plate with 3 screws provided.
Be sure to tighten all screws. (Fig. 2)
Fig. 2
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
-
-
o
o
Mounting plate
Square connectors
Light kit
assembly
Screws
7
Ceiling Fan LED Universal Light Fixture Kit |
INSTALLING THE LAMPS & GLASS SHADE
1. Install both of the 9 watt E26 LED lamps (provided), one in each
fixture socket. (Fig. 3)
2. Mount the glass shade to the light kit by turning the glass shade
clockwise. DO NOT OVER TIGHTEN. (Fig. 3)
3. Your installation is now complete. Restore electrical power and
enjoy your new ceiling fan light kit.
Fig. 3
Lamp socket
Lamps
Glass shade
8 | KICHLER.COM
FCC INFORMATION:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
9
Ceiling Fan LED Universal Light Fixture Kit |
KICHLER LIGHTING
7711 EAST PLEASANT VALLEY ROAD
CLEVELAND, OHIO 44131
CUSTOMER SERVICE 866-558-5706
8:00 AM TO 5:00 PM EST, MONDAY - FRIDAY
Page is loading ...
Page is loading ...
TABLA DE CONTENIDO
REGLAS DE SEGURIDAD ...........................................4 4
CONTENIDOS DEL PAQUETE ..................................5 5
INSTALANDO EL KIT DE ILUMINACIÓN ..............6-7
INSTALANDO LAS LAMPARAS Y
LA SOMBRA DE CRISTAL ..............................................8
ADVERTENCIA FCC ..................................................... 9 9
3
Ventilador de techo LED Kit de iluminación universal |
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
KICHLER LIGHTING
7711 EAST PLEASANT VALLEY ROAD
CLEVELAND, OHIO 44131
CUSTOMER SERVICE 866-558-5706
8:00 AM TO 5:00 PM EST, MONDAY - FRIDAY
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
KICHLER LIGHTING
7711 EAST PLEASANT VALLEY ROAD
CLEVELAND, OHIO 44131
CUSTOMER SERVICE 866-558-5706
8:00 AM TO 5:00 PM EST, MONDAY - FRIDAY
/
