1. Open the package at bottom on the carton. Gently pull out the cardboard
tray to expose the wiring.
2. Gently pull product and wires out of the box. Disconnect the wires from the
“ Try Me “ display wiring. ( See Photo #1.) Do not worry about disconnecting
the “ Try Me “ wires from the box. This “ Try Me “ wiring that is attached to
the box will not be reused as it is for store display purposes only.
3. Remove all pieces from carton. You should have an Adapter and the tree top.
4. Open the small box that contains the adapter and remove twist tie on wires.
Connect the tree top wire to the Adapter. ( See Photo#2 )
ASSEMBLY INSTRUCTIONS
Photo #1
“Try Me”Wiring
Disconnect This Wire
Tree Top Wiring
5. Plug the power cord into a standard 110 to 125 volts A.C. outlet. It is
acceptable to use an extension cord if needed. The tree top will light up and
begin changing colors.
Tree topper holder
Photo #2
Tree Top Wire
Connect
/
