SPEEDI-WIND CAP WDC08 Operating instructions

WIND DIRECTIONAL CAP

MAINTENANCE INSTRUCTIONS

Maintenance instructions must be followed for Warranty compliance.

The Wind Directional Cap Hood cannot be assembled incorrectly, due to the varied

bolt size on the mounting plate. Unscrew the wing nuts and position the Hood on the

flat portion of the Spindle, insert the threaded rod ends throught the holes and tighten

wing nuts with pliers. **Some models have a metal tab that must be bent around the

Spindle to secure the top cap into place.

Be sure that the cap base is level and then sheet metal screw it into place in order

tp provide you with the un-restricted swing action necessary for proper function.

Most Wind Directional Caps will not require maintenance under most conditions but

there are some conditions that could create a need for periodic service. If the Wind

Directional cap becomes sluggish or in a fixed position add a small amount of grease

utilizing the provided Zerk grease service fitting.

USE ONLY HIGH TEMPERATURE GREASE RATED AT 450 DEGREES F or HIGHER.

High temperature grease can be found at most automotive repair or supply stores.

Applied Applications International LLC

500 Colorado Street

Kelso, WA 98626

P: 866-794-7900

F: 360-577-0876

www.appappint.com

09-2010

This manual is also suitable for

Download PDF