Comfort-Tech Grip-Wrap
Installation Instructions: For best results, apply at room temperature. Begin with the end labeled “Start”
with beveled surface down against the grip, tighten wrap snugly in a counter- clockwise direction,
overlapping the bevel, being careful not to over-tighten. When finished, tuck the end under the last
wrap. Option: Use electrical tape to tape over last 1” on wrap. If the grip is not completely covered,
stretch the wrap more; if it is over- covered, stretch the wrap less.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Vestil POW-CAR Owner's manual
-
3M PILC Accessory Oil Stop Kit 5110-OS, 15 kV Operating instructions
-
3M 8600M: Décor Overlaminate 8600 Series User guide
-
Vision Fitness Speaker System ST730 User manual
-
Adventure Parks 30-3511 Installation guide
-
Univex 6512 User manual
-
Club Weider 16.8ST User manual
-
Zip Line Fun 30-9031 Installation guide
-
Zip Line Fun 30-X90 User manual
-
