Contec POW300X Owner's manual

Type
Owner's manual
1
POW300X
300W ATX Power Supply
POW300X User’s Guide
CONTEC CO.,LTD.
Thank you for purchasing the POW300X. POW300X is a power supply for FA-UNIT series exchange.
Please use it referring to the following matter.
Product Configuration List
- Power Supply…1
- Screws…4
- User's Guide (this guide)…1
Exchange Process
CAUTION
The chassis shape and the cover attaching/detaching methods depend on each model.
For details, refer to the manual for the chassis in use.
(1) First remove the power cord from the chassis. And remove the screws that hold in place
the cover. Then open the cover.
Cover
Screw
Rear
Power Cord
POW300X User’s Guide
POW300X
2
(2) Unplug the power supply cables from the backplane and drive.
Power Supply Back Plane, or Mother Board
HDD, FDD, etc.
(3) Remove four screws on that hold in place of the power unit from the rear panel.
Then take the used power unit out.
If the power unit is fastened inside with two screws, remove them as well.
Rear
Power Supply
Screw
If fixed two screws inside,
remove two screws inside,too.
POW300X User’s Guide
3
POW300X
(4) Replace this new power unit into the chassis. Fix the unit to the rear panel with four
screws on rear. Tighten the screws so that the unit is held in
place.
If the power unit is fastened inside with two screws, tighten them back in place.
New
Power Supply
Rear
Screw
(5) Connect between the fan and the backplane, and the power supply based on the following
diagram, respectively.
Power Supply
Back Plane, or Mother Board
HDD, FDD, etc.
POW300X User’s Guide
CONTEC CO., LTD. December 2005 Edition
3-9-31, Himesato, Nishiyodogawa-ku, Osaka 555-0025, Japan
Japanese http://www.contec.co.jp/
English http://www.contec.com/
Chinese http://www.contec.com.cn/
No part of this document may be copied or reproduced in any form by any means without prior written
consent of CONTEC CO., LTD. [12052005]
[12052005] Management No. A-51-195
Parts No. LYFU961
(6) Fix the chassis cover with screws. Tighten the screws so that the cover is held in place.
Connect the power cord.
Cover
Screw
Rear
Power Cord
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Contec POW300X Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI