2. Pure Acoustics
  3. BQ360

Pure Acoustics BQ360 Installation guide

  • Hello! I've reviewed the installation instructions for the Pure Acoustics BQ340, BQ350, and BQ360 in-wall speakers. This document provides a step-by-step guide on how to install these speakers, including how to mount them using the provided template, connect the wiring, and secure the speaker to the wall. I'm ready to answer any questions you have about this process or the speakers themselves.
  • What gauge speaker wire is recommended?
    How is the grill removed?
    How many screws are there around the perimeter of the speaker?
Take the cardboard template that comes with the speakers and
place it where you want the speaker to be mounted.
Draw around the template and cutout the speaker mounting hole.
Run quality speaker wire (12-16 gauge ) to that location.
Carefully pry off the grill from the speaker either using a small
screwdriver at the edge of the grill or with a small awl catching the
grill by one of its holes.
Connect the speaker wire to the speaker terminals and insert the
speaker into the hole.
There are screws around the perimeter of the face of the speaker
(6 on the inwalls). These screws connect to ‘wings’ in the rear of the
speaker which will swing out and clamp the speaker to the wall as they
are tightened.Secure the speaker to the wall by tightening these screws
until the speaker is securely mounted.
Reattach grill.
That’ s It ! Enjoy !
In-wall Speakers
Cutout Dimension
BQ340: 193x119mm
BQ350: 250x160mm
BQ360: 274x189mm
BQ340/350/360
/