2. FM Mattsson
  3. O-ring 19,1x1,6

FM Mattsson O-ring 19,1x1,6 Operating instructions

  • Hello! I've reviewed the instructions for the temperature knob. This document provides information on disassembling, reassembling, and calibrating the temperature knob, including adjusting the spindle, aligning the control knob, and ensuring proper scalding protection. I'm ready to answer any questions you have about these procedures.
  • How do I make the water cooler?
    How do I make the water warmer?
    What temperature should I calibrate to?
Rev. 000 - 18.03.28 Art. nr 100 69 24
SV: Åtgärd för själv-vandrande temperaturvred
EN: Measure for self-moving temperature knobs
1
SV: Demontering
EN: Disassembly
2
OFF
SV: Montering
EN: Montering
Calibration of temperature:
Remove the cover and dismantle the
temperature control knob. Turn the spindle
clockwise for cooler water and anti-clock-
wise for warmer water. When the correct
water temperature has been reached
(approx. 38°C), connect the temperature
control knob so that the button is aligned
with the marking on the mixer body.
NOTE! The stop lug for the scalding
protection ring should be aligned with the
marking on the mixer body.
For more information, see the respective
instruction for your thermostat.
3
4
5
For remounting, see disassembly
3780-2018 (19,1x1,6)
60 92 06.AE (19,1x1,6)
/