Phanteks Glacier G30 Strix Block and Backplate Owner's manual

Type
Owner's manual

This manual is also suitable for

INSTALLATION GUIDE V1.0
Asus ROG Strix RTX 3090/3080
GLAC IER BACKPLATE
PH-GB3090ASSRXBP_BK01/CR01
PACKAGE CONTENTS
WARNING -
have been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s)
occurring to your components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below
instructions, or due to failure or defect in the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.
For latest version check www.Phanteks.com
M2.5x8 Flush Screws
QTY: 9
FINISH STEPS 1 TO 3 FROM THE WATER BLOCK INSTALLATION GUIDE BEFORE PROCEEDING:
STEP 4. APPLYING THERMAL PADS
GLACIER BACKPLATE
QTY: 1
thermal pads on the correct position on
the backplate.
This product requires the PH-GB3090ASSRX GPU water block. Please follow step 1 to 3 of the GPU
water blocks’ installation guide before proceeding.
both sides of the thermal pads.
Thermal Pads
QTY: 3
1
2 2
3
5
7
64
4
5
6
7
2
2
13
4
5
6
7
2
2
13
STEP 5. INSTALL THE GLACIER BACKPLATE
Carefully position the backplate onto the
graphics card. Align the mounting holes on
the PCB with the holes on the backplate.
Secure the backplate with 9 M2.5x8mm
STEP 6. CONNECT D-RGB LIGHTING
Connect the D-RGB cable to the D-RGB strip
in the water block.
STEP 7. INSTALLING FITTINGS
close the remaining ports with the two
included Stop Fittings.
Connect to
Phanteks Case / Motherboard Cable
Always perform a leak test before providing
power to any system components.
You can connect the D-RGB cable to a
compatible motherboard with the cable
that is included with the motherboard.
All Phanteks D-RGB products can be
daisy-chained together.
9x
  • Page 1 1
  • Page 2 2

Phanteks Glacier G30 Strix Block and Backplate Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI