This device complies with international standard IEC 60825-1: 2001-08, class 1 and class 2 laser products and also

Comply with 21 CFR 1040.10 and 1040.11 except for deviation pursuant to Laser Notice No. 50 dated 7/2001.

Operating temperate: between 0 ° C (32° F) to 40° C (104° F).

other than those specified herein may result in hazardous radiation exposure.

(which is invisible to the human eye) should not be pointed at anyone’s eyes.

1. Emission of a parallel beam of visible light

2. Maximum Power of 1 milliwatt CW, wavelength range 650±20 nanometers

3. Class 2 laser beam is emitted from the front of the device

4. Class 2 laser Safety Caution:

• Do not stare into beam

• Do not shine a laser pointer at anyone. Laser pointers are designed to illuminate inanimate objects

• Do not allow minors to use a pointer unsupervised. Laser pointers are not toys

• Do not point a laser pointer at a mirror-like (reflective) surface. A reflected beam can act like a direct beam

• Do not disassemble the device

• Do not use the device outside of its specified operating temperature range

1. In the absence of proper operation and if customer initiated troubleshooting is unsuccessful, switch off

KENSINGTON COMPUTER PRODUCTS GROUP ("KENSINGTON") warrants this product against defects in

material and workmanship under normal use and service for five years from the original date of purchase.

KENSINGTON, at its option, shall repair or replace the defective unit covered by this warranty. Please retain

the dated sales receipt as evidence of the date of purchase. You will need it for any warranty service. In order

to keep this limited warranty in effect, the product must have been handled and used as prescribed in the

instructions accompanying this warranty. This limited warranty does not cover any damage due to accident,

misuse, abuse or negligence. This limited warranty is valid only if the product is used with the equipment

specified on the product box. Please check product box for details or call KENSINGTON technical support.

EXCEPT FOR THE LIMITED WARRANTY PROVIDED HEREIN, TO THE EXTENT PERMITTED BY LAW, KENSINGTON

REPAIR OR REPLACEMENT OF THIS PRODUCT, AS PROVIDED HEREIN, IS YOUR EXCLUSIVE REMEDY. KENSINGTON

SHALL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING, BUT NOT

LIMITED TO, LOST REVENUES, LOST PROFITS, LOSS OF USE OF SOFTWARE, LOSS OR RECOVERY OF DATA, RENTAL

OF REPLACEMENT EQUIPMENT, DOWNTIME, DAMAGE TO PROPERTY, AND THIRD-PARTY CLAIMS, ARISING OUT

OF ANY THEORY OF RECOVERY, INCLUDING WARRANTY, CONTRACT, STATUTORY OR TORT. NOTWITHSTANDING

THE TERM OF ANY LIMITED WARRANTY OR ANY WARRANTY IMPLIED BY LAW, OR IN THE EVENT THAT ANY

LIMITED WARRANTY FAILS OF ITS ESSENTIAL PURPOSE, IN NO EVENT WILL KENSINGTON’S ENTIRE LIABILITY

EXCEED THE PURCHASE PRICE OF THIS PRODUCT. SOME STATES/COUNTIES DO NOT ALLOW THE EXCLUSION OR

LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY

NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER

must not be co-located or operating in conjunction with any other antenna or transmitter.

Note: This device has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment

causes harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

operate the device under FCC regulations and must not be made.

device should be made using only the shielded cables.

This product complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) This device

may not cause harmful interference, and, (2) this device must accept any interference received, including

interference that may cause undesired operation. As defined in Section 2.909 of the FCC Rules, the

responsible party for this device is Kensington Computer Products Group, 333 Twin Dolphin Drive, Redwood

Shores, CA 94065, USA.

provisions of applicable EC directives.

For Europe, a copy of the Declaration of Conformity for this product may be obtained by clicking on the