Dell PowerVault MD1000 User guide

About Cautions

CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.

Replacing an EMM

CAUTION: Only trained service technicians are authorized to remove the enclosure cover and access any of the

components inside the enclosure. Before performing any procedure, see your Product Information Guide for

complete information about safety precautions, working inside the enclosure and protecting against

electrostatic discharge.

The Dell™ PowerVault™ MD1000 storage enclosure with redundant enclosure management contains

two enclosure management modules (EMMs). For information on replacing an EMM, see "Removing

and Installing an EMM" in the Dell™ PowerVault™ MD1000 Storage Enclosure Hardware Owner’s

Manual.

NOTE: If you have two EMMs installed, both must be running the same firmware level. After replacing an EMM,

verify that both EMMs have the same firmware level. You can download firmware updates for your storage

enclosure using a Dell Update Package available at support.dell.com.

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell, PowerVault, and the DELL logo are trademarks of Dell Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their

products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

April 2006

JJ974am0.fm Page 9 Tuesday, March 21, 2006 1:38 PM