Maytag 27-inch electric built-in single cavity wall oven Installation guide

Brand: Maytag

Model: 27-inch electric built-in single cavity wall oven

Type: Installation guide

Z_OEdwardsStreet,SE

Cleveland,Tennessee37311

fei:423-472_33_3

F3x:423-478-6710

INSTALLATION INSTRUCTIONS

27-INCH ELECTRIC

BUILT-IN SINGLE CAVITY WALL OVEN

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE

WIRING

The neutral of this unit is grounded to the frame through the _en grounding wire, (The green and the white

wire are twisted together at the termination of the conduit). If local conditions doe not permit _ounding of the

neutral, untwist the green wire and connect the green wire to ground in accordance with local codes. Connect

the white neutral to the service neutral.

PROPER ELECTRIC SUPPLY

You must provide an adequate electrical supply outlet as required for your oven. Check with local utility for

governing electrical codes and ordinances. In the absence of lncal electrical codes, the National Electric Code,

NFPA No. 70, governing electric range installations must be followed. A copy of the National Electrical

Code, NFPA No. 70, can be obtained by writing to:

National Fire Protection Association

Batterymarch Park

Quincy, MA 02269

A three-wire, single phase, AC 120/240 volt or 120/208 volt, 60 Hz electrical system (properly fused to meet

NFPA No.70) must be provided. The oven circuit should be fused with a 30 ampere fuse if it is the only unit

on the circuit. Size No. 10 wire (minimum) may be used if the oven is the only appliance on the circuit. If

smaller sizes of wire are used, the unit efficiency will be reduced and a fire hazard may be created.

It is advisable that the electrical wiring and hookup be accomplished by a competent electrician.

Make electrical connections with a 120/240 volts or I20/208 volt, 60 Hz, single-phase, AC three-wire electri-

cal system. All wire connections must be in accordance with local codes and properly i_ulated. Be sure to

check local codes for wire size and installation requirements. Unit must be properly grounded in accordance

with local wiring code.

SERVICE

Interrupt the source of elect_city to the unit be disconnecting the fuse or eircu# breaker when attempting to

repair or service the oven. Failure to do this could result in a dangerous or even fatal shock.

SPECIFICATIONS

Voltage 120/240 Volts AC 120/208 Volts AC

Amperage 24.2 Amps 21. I Amps

Watts 5700 4300

Frequency 60 Hz

Weight 142 lbs.

2_0EdwardsStta.=t.SE

Clove)ant1,Tennessee37Sli

Tel -'Z2-47Z-3233

Fax:47_2-473-6710

1. CAUTION: Some 27-Inch built-in cabinets may not be wide enough, due to their construction to allow

this installation.

2. Cut hole in cabinet to mount oven. Cut out in cabinet should be level and straight. NOTE: Them are no

provisions to level the unit after it is installed. An oven that is not level will cause poor baking results.

3. Install plywood floor per following instructions.

4. Assemble unit to the cabinet with the four No, 8 x 1" screws supplied with unit inside of envelope contain-

ing these instructions. Pra-dril! holes in cabinet for attachment screws using 1/8" drill, Oven mounting boles

are in each corner of front panel.

5. See previous page for electrical hook-up.

6. See User's Manual for operating instructions and warranty.

7. Packed with this unit is an additional bottom trim to cover the bottom edge of the cabinet cutout, If

needed, loosen the screws on the underside of the front closure and slip trim in place with the solid flanged

side down. Retighten screws.

TRIM J_

CAtqN_r

j •

27" 24" CAUTION: If cabinet doors are provided above

wall oven, a minimum spacing of3_',t" is required

rain. _ rain. for V=" thick doors. For thicker doors,increasethe

Y 1" for each %" additional thickness.

CAUTION: Oven vent.

0o not locate do not obstruct.

junction box,'--_ 2g-3/8"

in shaded area. |

Provide clearance k,,'E Typical corner

ho(e for conduit"" " ".,_j 4" to screw.

accessto junction "

33" #8 x 1 screw.

box below ply- (-

wood floor. I floor

] 28-1/8"

Construct Sie" r, n.'_ .._

plywood floor flush \

with bottom of open-

ing. Floor must be

cagabie ofsupporting 23. ,NOTE: Do notb)ock air

142 Ibs. _ intake slotsalong sides

and bottom of unit.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

Maytag 27-inch electric built-in single cavity wall oven Installation guide

Maytag 27-inch electric built-in single cavity wall oven Installation guide

Maytag 27-inch electric built-in single cavity wall oven Installation guide

Related papers

Other documents