Signature Hardware 433221 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
433221
Category
Sanitary ware
Type
Installation guide
1Cooper Shower Valve Installation Instructions
COOPER SHOWER VALVE INSTALLATION
TOOLS AND MATERIALS:
We recommend consulting a professional if you are unfamiliar with
installing plumbing fixtures. Signature Hardware accepts no liability
for any damage to the home, product, or for personal injury during
installation.
Unpack and inspect the product for any shipping damages. If you find
damages, do not install. Contact Customer Relations at
1.866.855.2284.
Observe all local plumbing and building codes.
For the following installation instructions it is assumed that the in-wall
plumbing has been prepared, and ready for rough-in procedures.
BEFORE INSTALLING INSTALLATION
1. Install the valve body as specified in the above diagram.
2. Route, assemble, and connect all in-wall piping to and from the shower valve. Make connections
appropriately depending upon the type of pipe that is being used. For copper pipe, soldering will be
required and should be completed by a licensed plumber. Apply plumber’s tape to any threaded connec-
tions if applicable. Install any wood blocking that is necessary to support the piping and valve.
3. Once all piping is routed and connections have been made, use a ½” test plug to perform a water
pressure test. Turn on the main water supply to your home and water test the installed plumbing. Ensure
that there are no leaks, then shut the water off. Remove the test plug. Note: Water pressure testing
should be performed by a licensed plumber if you are not familiar with this procedure.
IMPORTANT: COMPLETE THE CONSTRUCTION OF YOUR WALL, INCLUDING ANY FINISHED WALL MATERIALS
SUCH AS TILE, BEFORE PROCEEDING WITH THE REMAINDER OF THE INSTALLATION.
4. Once the finished wall is complete, remove the protective sleeves from the valve.
5. Complete the installation of the shower valve by attaching the trim pieces.
The installation diagram
is only for reference and
subject to the real
objects.
*
outlet
cap
M5 screw
handleescutcheonfinish wall
valve bodyself-tapping screw
wall anchor
ø8 hole
30~55
hot
water
inlet
cold
water
inlet
Drill
Phillips
Screwdriver
Hex Wrench
Level
Drill Bit
½" Test Plug
Soldering Kit
(for copper pipe)
Wood Blocking
SKU(s): 940965
  • Page 1 1

Signature Hardware 433221 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
433221
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents