2. Seizmik
  3. 04017
04017

Seizmik 04017 User manual

  • Hello, I'm your chat assistant, and I've reviewed the Installation & Operations Manual for the SEIZMIK Dust Panel 04017. This document contains step-by-step instructions on how to properly install the Dust Panel on your full-size Polaris Ranger UTV, including securing the straps and adjusting them for a tight fit. The manual also gives you tips for easier installation. I'm here to answer any questions you may have about the installation process or the product itself.
  • What should I do if some straps interfere with the hardtop mounting configuration?
    What is a good way to get the straps tight?
    What should I do if I have any questions or need assistance?
2. Locate the straps (wide and thin) running down the
length of the rear vertical ROPS bar. Fasten around the
bar. Repeat this step for the opposite side.
Tip – A good way to get the straps tight is to rotate
the top around the bar like in the picture on
the right.
1. Lay the Dust Panel over the roll cage of the vehicle
making sure the straps are on the outside of the roll
cage. Secure the top straps first. If some straps interfere
with the hardtop mounting configuration, omit the
attachment of those straps.
Tip – Lift the dump bed to make installation easier.
3. Adjust the straps for tight fit. Congratulations – You have now finished the
installation of your Dust Panel.
Installation & Operations Manual
Full Size Polaris Ranger UTV Dust Panel
Part #04017
Part# 04017
How to get Help - If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between
9:00AM and 5:00PM EST. You can email us at support@seizmik.com, visit www.seizmik.com to download installation guides and
product info, or contact your pow1ersports dealer where you purchased your Seizmik product if you need additional assistance.
/