2. Seizmik
  3. 1000 Seizmik Fender Flare
1000 Seizmik Fender Flare

Seizmik 1000 Seizmik Fender Flare User manual

  • Hello, I've reviewed the Seizmik Fender Flare manual for the General 1000 67-10008 model. This manual provides detailed step-by-step instructions for the installation, including specific steps for different fender areas and the proper use of mounting hardware. I'm here to answer any questions you may have about the installation process or the product itself.
  • What should I do if I have questions or missing parts?
    What kind of drill bit should I use to drill into the body of my vehicle?
    Should I make any modifications to the product or installation procedure?
General 1000 Seizmik Fender Flare Manual
Part # 67-10008
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully
follow the instructions in this manual and make no modifications.
If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM
and 5:00PM EST. You can email us at [email protected]
1
Always observe the warnings and precautions in this manual when using your Seizmik products. For best results, carefully
follow the instructions in this manual and make no modifications.
If you have any questions, comments, need assistance, or are missing parts, please call 1-866-838-3366 between 9:00AM
and 5:00PM EST. You can email us at [email protected]
2
Screw directly into vehicle body,
may or may not back with push nut
Metal Bracket, go to page 4
Remove stock fastener and re-install with fender flare
Use a 3/8” drill bit to drill into body of your
vehicle and install push rivet
Install a countersunk bolt, washer,
and M6 nut
3
Attach bracket to fender flare with countersunk bolts and aluminum washers.
Loosely thread both Nylock Hex Flange nuts, then tighten fully.
Bends may flatten during shipping
Fender Flare Metal Bracket
Install all brackets
4
Outer Side Flare Inner Side Flare
To start, connect side inner
flare to side outer flare.
Then, remove Polaris
push rivet and use a
M6x20mm bolt and M6
nut to install fender
5
Middle Fender
Middle Fender
Install screw and
back with push nut
6
Screw directly into body
for each hole location
Line up the highlighted edge with
the inner edge of your vehicle.
7
Rear Fender
Front Fender
First, remove Polaris bolt from
vehicle, install front fender with
Polaris bolt.
Then, adjust fender to desired
coverage and install screw,
back with push nut
8
Drill and install Push Rivet
Install screw and push nut
Install screws
9
NOTE: Depending on where
you place the front fender you
may not be able to back this
screw with a push nut
Front Fender
/