1

Q-500GB series Spice Grinder

ATTENTION

⚫ New user or repairing this product must be performed by the experts or qualified person or those who have gotten

the license of installation, or those who are authorized by the manufacturer.

⚫ When installation or maintenance, please obey the following instructions carefully to ensure the safety use of this

appliance.

damage.

⚫ When it needs to be repaired, please ask for expert, and use the original fitted spare part. It will be dangerous if not

following the above requirements.

⚫ This appliance is just for commercial using, not for any other use, otherwise, it may be dangerous.

⚫ Do not rinse the equipment with water directly.

⚫ Clean the surface of stainless steel periodically with appropriate method to prevent any damage brought by

oxidization or any other chemical interference.

Directions for use

Open the cover, material is loaded

Just boot, if meet crushing stuck blade, make the motor does not turn (will hum bass sound), immediately shut off the

power, to prevent motor burn out, then the card removed, to boot.

General Chinese medicine pieces just half a minute, hard powder can be a minute.Grinding time shoulds not be too long,

prevent the fine powder hot glue tank.

The machine can't long time continuous operation, the boot time shall not exceed 5 minutes every time, the processing

quantity, middle must rest (pause) to prevent damage to the motor bearing overheating

Use for a long time, carbon brush and blade wear serious when you want to change the new (spare parts)

To prevent the machine fell to the ground and broke

Material must be dry, unfavorable moisture and grease

The cover is opened, please do not start switch

Causes: voltage instability or super load using overload protector pop-up, protect the motor

Method: please immediately cut off the power supply, lighten the load, overload protector, red button, can be normal use

Spare parts: (1)two blades (2) the brush brush

2

Buzzing sound, after electrify motor rotate too slow or not

Reason: please check whether the crushing material moisture, excess stuck blades

Please check whether the carbon brush is badly worn

Excluded methods: immediately cut off the power and remove the jammed material, change of carbon brush

If after electrify motor does not turn