Page 1 of 3
Adult Assembly
ASSEMBLY INSTRUCTIONS
Before assembling your esk, please read through theseD
LEXI DESK WITH DRAWER CHARGING STATION
LEXI DESK WITH DRAWER CHARGING STATION
Hexagon Wrench
AD
BE
C
Flat washer - 8 pcs Wooden Dowel - 4 pcs
Spare - 2 pcs
Spare - 1 pc
Hexagon nut - 8 pcs Wood Screw - 4 pcs
Spare - 2 pcs
Spare - 1 pc
Hexagon wrench - 1 pc
PARTS LIST
01
02
03
TOP PANEL 1 PC
4 PCS
2 PCS
LEG
SIDE PANEL
01
02
03
NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE HEXAGON NUT, WASHER, WOODEN DOWEL,
OR WOOD SCREW ARE DAMAGED DURING ASSEMBLY.
ATTENTION! If you receive a damaged or defective item,
please contact Atlantic Furniture at [email protected] 1-800-955-3726 / M-F 9:00-5:00 EST
instructions carefully and familiarize yourself with the different parts.
READY
ASSEMBLE
TO
Page 2 of 3
STEP 1
Attach the legs (02) to the top panel (01) using flat washers (A) and hexagon nuts (B),
tighten with hexagon wrench (C), as shown below.
02
02
02
02
A
A
B
B
01
A
B
02
A
B
Adult Assembly Flat Washer Hexagon Nut
AB
LEXI DESK WITH DRAWER CHARGING STATION
note: panel in center
03
D
D
STEP 2
Install wooden dowels (D) into the locator holes on (03) as shown below.
Repeat with the other panel.
Adult Assembly
Wooden Dowel
Wood Screw
03
03
D
E
E
STEP 3
E
Attach side panels (03) to desk aligning the
dowels (D) with the holes in the apron.
Be sure the panel is centered before
tightening the wood screw (E).
D
D
E
Congratulations!
Your esk is now ready for use.D
Page 3 of 3
To ensure lasting safety, we recommend that you periodically check
that all screws are tight and all parts are secure.
LEXI DESK WITH DRAWER CHARGING STATION
/
