Catalog No. 130102 Rev. B June 2001 1
Avaya X330F2 Installation Guide
The Avaya X330F2 Expansion sub-module provides two fiber Fast Ethernet
100Base-Fx ports.
Installing the Expansion Sub-module in the Avaya P330
1 Remove the blanking plate or other sub-module (if installed).
2 Insert the sub-module gently into the slot, ensuring that the Printed Circuit
Board (PCB) is aligned with the guide rails.
The PCB not the metal base plate fits into the guide rail.
3 Press the sub-module in firmly until it is completely inserted into the
Avaya P330.
4 Gently tighten the two screws on the front panel of the expansion sub-module
by turning the screws.
Caution: The expansion sub-modules contain components sensitive to electrostatic
discharge. Do not touch the circuit board unless instructed to do so.
Removing an Existing Expansion Sub-module
1 Loosen the screws by turning the knobs.
2 Grasp the two knobs one near each side of the front panel, and pull gently but
firmly towards yourself.
3 Insert another expansion sub-module or the blanking plate.
Note: The Avaya P330 switch must not be operated with the expansion slot open;
the expansion sub-module should be covered with the supplied blanking plate if
necessary.
Note: X330F2 sub-modules are hot swapable and can be inserted or removed in an
operating base unit.
Avaya
Avaya X330F2 Installation Guide
2 Avaya X330F2 Installation Guide
Cabling
A fiber optic cable may be connected to either of the 100Base-FX ports, via a pair of
SC connectors. The maximum fiber cable length connected to a 100Base-FX port is
412 m (1,352 ft) when operating in half duplex, and 2 km (6,562 ft.) when operating
in full duplex, over MMF.
Fiber optic cable should be MMF cable, 62µm or 50µm.
Please refer to the P330 User’s Guide for more detailed information.
Avaya.com
All trademarks, registered trademarks, service names, product and/or brand names are the sole property of
their respective owners.
Copyright © 2001, Avaya Inc. All rights reserved.
/