2. AudioQuest
  3. FLX 16-2

AudioQuest FLX 16-2 User manual

  • Hello! I am an AI chatbot trained to assist you with the AudioQuest FLX 16-2 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
If you have any questions or concerns – please call AudioQuest at (949) 585-0111
or email: [email protected]
1
FLX 16-2, FLX 14-2
Bulk Spool Termination Manual
Thank you for choosing AudioQuest. This manual provides instruction for preparing
and terminating a bulk (unterminated) speaker cable.
Please be careful when using sharp tools. We recommend wearing safety glasses.
To terminate AudioQuest speaker cables you will need the following tools:
• Sharpknifeorrazorblade
• 1.5mm.Hex(Allen)wrench(suppliedwithSureGrip300,500&1000
Seriesspade&bananaplugs)
• SmallPhilipsscrewdriver(for500and1000Seriesconnectors)
We recommend using the following tools, which can be found at:
audioquest.com/accessories, then click “Tools.”
• Paladinjacketstripper
• Idealarticulatedwirestripper
If you have any questions or concerns – please call AudioQuest at (949) 585-0111
or email: [email protected]
2
Step 1
Measure about 5.5” of cable. Using a sharp
blade or a jacket cutter, carefully strip back the
outer jacket and remove. This will expose the
two conductor wires and two llers inside.
Step 4
Insert the Red wire into a red-stripe speaker
connector and tighten the connector’s screws
using a hex allen wrench. Insert the Black
wire into a black-stripe speaker connector and
tighten the connector’s screws using a hex allen
wrench.
Step 2
Using a wire cutter, remove the two thin black
llers. Be careful not to cut the conductor wires.
Step5
Ensure all connections are secure.
Step3
Using a wire stripper, remove ½” of insulation
from each wire.
FLX16-2&FLX14-2
/