Use the Allen key
and screws with flat
washers
to attach the intermediate
piece
to the clamps
. Note that the screw
hole at the top of the intermediate piece points
straight forwards.
Drill holes up to 5 centimetres deep and screw
the ceiling plate
with the long screws and
plugs
.
Attach the projector to the hanging bar
and
tighten the last bolts
with the Allen key
.
It’s done!
Tighten the clamps
almost completely with
the screwdriver. To do this, use the bolts with
raised washers
. Take the intermediate
piece
to check that the screw holes are
properly positioned. If this is the case, tighten the
clamps to the projector.
Place the cover
on the ceiling plate
and
attach the bar to the suspended ceiling plate
.
You do this with the bolts
and the Allen
key
. Please note: on the photo the ceiling
plate does not hang, but for you it does. Also
check that the nuts are present in the white plate
of the ceiling plate. If not, you will find them loose
in the box.
Mark the drill holes using the ceiling plate
.
So you’re sure you’re drilling in the right places.
BBBB22
MARK OFF THE DRILL
HOLES
1. MOUNT THE CEILING
PLATE
2. MOUNT THE COVER
AND BAR
3.
TIGHTEN THE
INTERMEDIATE PIECE
5. HANG UP THE PROJECTOR
6.
SCREW THE CLAMPS IN
PLACE
4.
Prior to drilling:
Use the pipe locator to check
if there aren’t any pipes or
cables in the ceiling.
Suitable ceilings:
Solid concrete
Drywall
Coolblue isn’t liable for any damage, accidents,
or arguments with boy/girlfriends as a result of
incorrect installation. Not sure if you can do this
on your own? Ask a skilled installation expert
for advice.
CHECKLIST.
You’re 50% there.
Do you have a question?
Coolblue.nl/en/
customer-service