Carrie Elizabeth Printable Ring Size User guide

Printable Ring Size Guide

This guide is designed to be used with a ring that perfectly fits the finger you intend to wear your

new ring on. For the most accurate measurement, use a ring with a similar band width and style to

the ring you wish to buy

Step 1

Print this page at 100% on a full A4 page, make sure you don’t select the ‘scale to fit page’ or ‘shrink

to fit page’ options. To check the print size is correct, the line below should measure 5cm

Step 2

Place the ring over the circles below and match the inside edge of the ring to the circle closest in size.

Make sure you select the circle which completely fills the inside of the ring

Step 3

Your CE ring size is the size shown within the circle. If your ring falls between two sizes, then we

recommend ordering the larger size

5cm

Don’t Have A Printer?

No problem! Alternatively, if you have an existing ring that fits the finger you intend to buy your new

ring for, you can measure the inside diameter of this existing ring to determine your size. Simply

follow the steps below:

• Place the ring on a piece of paper.

• Using a pen, make a mark inside the ring at opposite points.

• Remove the ring from the paper and measure the distance between the two points with a

ruler

• With this measurement refer to the ‘Inside Diameter’ column of our Ring Sizing Table to

determine your correct CE ring size

XXS

XXL

14.5mm 15.5mm 16.5mm 17.5mm 18.5mm 19.5mm 20.5mm

Download PDF