Page is loading ...
Installation Guide
ON
© VONN Lighting,2018
Model: VOI93364
Parts List
A.
B.
A
Circuit Box
Wire Connectors x 4
Hex Wrench
Make sure that you have all necessary parts by checking the parts list. If
any part is missing or damaged, please contact VONN Lighting
Customer Service at 888-604-8666 for a replacement.
Please read and comprehend the entire manual before attempting to
assemble, operate, or install the product.
VONN highly recommends to use a qualified, licensed electrician to install
the fixture.
LED INFO & WARNINGS
•
•
All parts must be used as indicated in these instructions. Do not substitute
any parts, leave parts out, or use any parts that are worn or broken.
•
Inspect the LED fixture prior to installation to make sure that it has not
been damaged during shipping.
•
Please handle the LED light with care when unpacking. Do not apply
pressure to the LEDʼs, do not open any factory sealed compartments, and
do not touch the LEDs with your hands.
•
Shut “OFF” the electricity at main fuse box.
•
•
Do not remove or replace VONN manufactured parts that are provided
with the fixture.
VONN Lighting
Tools You May Need
GOGGLES
TAPE MEASURE
RUBBER
GLOVES
B
12V AC Low Voltage Fixture (TRANSFORMER IS REQUIRED)
•
© VONN Lighting,2018
Legend
L = Live/Hot/Black
N = Neutral/White
= Ground/Green
ON
ON
Circuit Box
4. Turn Power ON
Turn electricity “ON” at main fuse box.
•
A
B
B
Plastic Housing
Plastic Housing
Ground
Installation Hole Size
Refill with pea gravel
or sand
Ø5.25”
Ø135mm
Ø6”
Ø155mm
•Remove fixture from plastic housing.
•Thread supply wires through plastic housing.
•Insert plastic housing into prepared concrete
ground.
1. Prepare Hole
Prepare concrete for plastic housing.
3. Supply Wires:
Ground Wires:
Connect White (Neutral Wire) from fixture to power White
(Neutral Wire).
Connect Green (Ground Wire) from fixture to supply Green
(Ground Wire).
Twist wires together clockwise and secure with wire
connector (A).
Connect Black (Line Wire) from fixture to power Black (Hot
Wire).
•
•
•
•
2. Remove Fixture
•Tuck wires in plastic housing. Insert fixture into plastic housing.
•Secure fixture by tightening screws with hex wrench (B).
/
