1
Installation Instructions for
On one end of the fixture, place the large endcap, insert, and small endcap onto the nipple, then secure them in place by
screwing the finial onto the nipple.
Install the diffuser by carefully sliding it down the channel and into the assembled endcap, then secure the diffuser in place by
installing the remaining endcap.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen key.
1
2
3
1A
4
5
Cook Wall (LED)
1.0
WB1830-WB1831-LED
W 1830, WB1831-LEDB
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
For a complete list of dimmers, visit out website at www.Feiss.com
JUNCTION BOX
MOUNTING
PLATE
5
6
ALLEN KEY
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
NIPPLE
2
7
6
7
SET SCREW
DIFFUSER
INSERT FINIAL
LARGE
ENDCAP
SMALL
ENDCAP
FIXTURE
ASSEMBLED ENDCAP
CHANNEL
Page is loading ...
Page is loading ...
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.Feiss.com
© 2017 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
