2. Rowlinson
  3. Rectangular Patio Planter

Rowlinson Rectangular Patio Planter Assembly Instructions

  • Hello! I have reviewed the assembly instructions for the Rowlinson Rectangular Patio Planter SS429. The document provides step-by-step guidance on assembling the planter, including panel connections and floor installation. I understand the importance of using proper tools like a mallet and drill for successful assembly. I am ready to answer any questions you have about this product and the instructions.
  • What tool is recommended for tapping panels together?
    How many people are needed for assembly?
    What size drill bit is needed for pilot holes?
1. Connect the ends and side panels
Interlock the ends and side panels as shown. If necessary use a mallet and tap
them till they are fully inter-locked. Secure using 4 x 100mm screws in each
corner, screw through the end panels into the ends of the side panels.
2018 © Rowlinson Garden Products Ltd
Before assembly
• We recommend that time is taken to read the instructions before
starting assembly, then follow the easy step by step guide.
The instruction sheet is only a guide to the assembly.
Certain items may not be shown to scale.
• Check all components prior to assembly
• Drill all components where indicated.
• This product should be assembled by two people
• Never attempt to erect the assembly in high winds.
Recommended tools for assembly
• Mallet
• Cross head screw driver
• Drill with 2mm diameter drill bit
x 2 Drill
3. Turn planter over
With a person at each end carefully turn the planter the right way up.
English SS429
Assembly Instructions
Rectangular Patio Planter
We constantly improve the quality of our products, occasionally
the components may differ from the components shown and are
only correct at time of printing. We reserve the right to change the
specification of our products without prior notice.
2. Floor
With the planter upside down, place the floor onto the planter, ensure that the
floor boards fit within the side panels, tap into place with a mallet if necessary.
Secure the floor using 6 x 80mm screws as shown
Drill
Drill
Drill pilot holes in the end panels with a 2mm drill bit
for each screw in this section.
Drill pilot holes in the end panels with a 2mm drill bit
for each screw in this section.
Please Note:
To distinguish between the top and bottom edge
of each side and end panel. The bottom edge has
a row of nails along it.
ROWLINSON GARDEN PRODUCTS LIMITED
Green Lane
Wardle, Nr. Nantwich
Cheshire, CW5 6BN
email: [email protected]
Help Line (Normal Office Hours) 01829 261 121
100mm
100mm
100mm
80mm
1
2
3
4
No. Components Qty.
1 Front panel (badged) 1
2 Back panel 1
3 End panel 2
4 Floor 1
No. Fixing Kit Qty.
5 80mm screws 6
6 100mm Screws 8
/