2. Futech
  3. Line Tracer

Futech Line Tracer Owner's manual

  • Hello! I've analyzed the provided instruction manual for the FUTECH Line Tracer. This document covers how to properly use the device to detect the laser beam. It explains how to attach the receiver, how the LEDs and sound indicate the position, and how to use the sound and accuracy settings. Ask me anything about using your device, I'm ready to help.
  • What happens when the laser beam is detected at the bottom of the recipient field?
    What happens when the laser beam is detected at the top of the recipient field?
    What happens when the laser beam is detected exactly in the middle of the recipient field?
    What does the sound button do?
LINE TRACER
1
1
1
14
5
7
4
5
7
9
4
5
7
4
5
8
8
2
2
2
2
3
6
off = 3sec.
7
9
6
3
4
9
3
3
4
6
9
6
4
Housing
1. Higher then target
2. Target
3. Lower then target
4. Vial
5. Receivereld
6. Power button
7. Buzzer-button
8. Accuracy
9. Buzzer-speaker
Use
1. Place the laser device in receiver mode.
Refer to the instruction manual of your laser device.
2. Attach the receiver to a wall or rod and make sure the receiver can detect the laser
beam with the receivereld.
∙ When the laser beam is detected at the bottom of the recipient eld (Target above
laser line), the top LED (1) next to the recipient eld (5) light up. Only when the
sound mode is activated you will hear a repetitive “Beep-Beep-Beep”. If this occurs,
move the receiver upwards.
∙ When the laser beam is detected at the top of the recipient eld (Target under laser
line), the bottom LED (3) next to the recipient eld (5) light up. Only when the sound
mode is activated you will hear a repetitive “Beep-Beep-Beep”. If this occurs, move
the receiver downwards.
∙ When the laser beam is detected exactely in the middle of the recipient eld (5), the
middle LED (3) next to the recipient eld (5) light up. Only when the sound mode is
activated you will hear a continious “Beep”.
Sound
The sound button (7) ensures that you can turn the sound on and off.
Accuracy (not available on all devices)
With this button you can switch between “normal accuracy” and “ne accuracy”.
INSTRUCTIONS
/