SKINXTC™ Worldwide
•Charge an initial 4 hours before switching on (do not use before charged)
•Plug USB cable into charge point located at base of device
•Press power button for 2 seconds to power on/off
•Charge 1-2 hours per week, or until lights stop flashing
•Warm Energy Heat ‘WHE’ lights up when power on/off
•Quick press power button to power on Microcurrent ‘MC’ light
•Quick press power button to increase Microcurrent levels 1 to 3
•Use a water-based conductive booster gels for WHE and microcurrent energy
•Apply water-based serum and products as part of skincare device routine
•Spritz mineral water to increase conductivity and hydrate skin during treatment
•Drink water prior to treatment to keep hydrated
•Clean conductive booster gel and product from device with a clean microfibre cloth
•The device is IPX4 water resistant; ‘can take light splashes of water from all directions’