SHIDU portable pa system User manual

portable pa system
Brand
SHIDU
Model
portable pa system
Type
User manual

This manual is also suitable for

SHENZHEN SHIDU DIGITAL CO.,LTD
21635866
29105099
Email:[email protected]
Website:www.10shidu.com
HaoWorks H2 User Manual
Please read the instruction carefully before using it.
Features:
1) This speaker can work with any devices (DVD, VCD, CD, LD, TV, MP3, Radio, Electronic piano, etc…) with AUX output.
2) SHIDU original sound amplification electroacoustic system, ma ximum output power 30W.
3) 5.25 inch bass speaker and 1.5 inch independent tweeter.
4) 7.4V 4000mAh A grade lithium battery, can support 5~6 hours working time.
5) With Bluetooth 4.2 icloud control, which support sync textbook a nd and music o nline playing, wireless Karaoke.
6) Double devices TWS Bluetooth Double channel.
7) Support FM,TF card, USB disk play m ode. Independent audio Input and Output interface.
8) One key to eliminate the original sound, switch freely between accompaniment and original.
9) UHF Wireless through-wall technology, high sensitivity Moving-Coil microphone, stable signal and clear sound.
Function Illustration
1.Mic
7.VOL
2.MIC PRIORITY
8.POWER
3.MIC VOL
9.INPUT
10.REC/PLAY
5.BASS
11.MUSIC/KARAOKE
6.TREBLE
12.PREVIOUS
13.PLAY/PAUSE
14.NEXT
15.AUDIO INPUT
Data Transmission)
17.TF
18. DC 15V IN 19.DEL REC 20.LOOPING 21.MUSICAL SELECTION KEY
Common Function Illustration
◎Vol: To adjust the main volume
◎TRELBE:To adjust treble effect
◎BASS:To adjust bass effect
◎MIC-VOL: To adjust the volume of MIC
◎Echo: To adjust echo effect of MIC
SHENZHEN SHIDU DIGITAL CO.,LTD
21635866
29105099
Email:[email protected]
Website:www.10shidu.com
HaoWorks H2 User Manual
Built-in MP3:
◎USB slot: Support USB flash drive,
◎TF card slot: Support TF card
◎
Support MP3 WAV W MA FLAC APE format
，
prominent sound quality
，
Hi-Fi stereo design
，
bring yo u whole new Music experience.
◎
Input: To select AUX in mode, Bluetooth mode, TF card mode & USB flash drive ,FM mode
◎PlAY/PAUSE: In audio playing mode, press it to pause; press it again to play.
◎Pre/PAUSE: Press to select previous or next audio file.
◎ Key: Press to sw itch between accompaniment and original in audio playing mode.
FM Function:
◎Switch on the speaker, short press "INPUT" to choose the FM mode with the screen showing Radio frequency; Long press to enter into
automatic channels searching; After searched successfully, the device will save the channel automatically. And pl
ease press or to
choose the saved channels.
AUX FUNCTION:
1. Connected an AUX cable with another device,please short press"INPUT" to AUX mode.
2. “MIC PRIORITY” function is worked during the AUX mode
REC Function:
1.
Connected with wireless or wired microphone, in any mode, press and hold on to enter into REC mode to record with inserting storage (USB
flash drive or TF card). Press ”REC/PLAY” again to stop recording, save ”REC/PL AY” the audio files and play the recordings.
2.In music mode, press ”REC/PLAY” to enter into recordings play back mode with inserting storages (which have recordings). It will play the last
recording by default and please press or to select the previous and next recordings.
3.
In recordings play back mode, please press “LOOPING” on remote control to select single cycle and a ll cycle.
Bluetooth Function:
1.Switch on the speaker and press "INPUT" to enter into Bluetooth mode. (The Bluetooth mode is ready with voice prompt “Bluetooth is waiting
for connection” and “BLUE” on the screen.)
2. Turn on the Bluetooth function of your devices and search “H2”. Click and it will be successfully with a voice prompt “Bluetooth is
connected”.
3.
After successful connection, it’s possible to play the audio files(Teaching Material,Training Material,Music) in your devices.It can also work with
the wireless microph one ,to realize Poetry recitation accompanied by music and Sy nchronous karaoke.
Double devices TWS Bluetooth Double Channel
Step1: Open two devices and press " INPUT " to enter into Bluetooth mode .Long press " INPUT "of one device to enter into pairing status .Bluetooth
icon of another will be light constantly which means TWS function is activated.
Step2: Enter into “ Settings “ of mobile and turn on Bluetooth function. Then please search " H2 " and conn
ect. Two devices play simultaneously
achieve a surrounded stereo sound.
Step3: Long press " INPUT " one of them, quit out the function.
About Charging:
1.Please use the standard adapter, the other end connects with the power supply AC 110~240V to charge. Please unplug the adapter timely after
fully charged (the charging time is normally 6~8 hours).
SHENZHEN SHIDU DIGITAL CO.,LTD
21635866
29105099
Email:[email protected]
Website:www.10shidu.com
HaoWorks H2 User Manual
2.Battery status: There are 4 battery indicators on the screen a nd each represents 25%. Full is 100%, 3 are 75%... Please charge it timely when the
speaker reminds with voice prompt “Low battery, please charge”. The battery indicator will blink when charging and it will stop blinking after fully
charged and 4 indicators are full.
Please charge it 1~2 hours more after fully charged to lengthen the life of battery. Please don’t ov er charge too much time.
3.Please recharge the b
attery within 48 hours if the battery is too low.Keep the battery have electricity even if it don't work for a long time.
Please recharge the battery in open area when it is completely discharged and automatic shut down to avoidcombustible.
Specification:
Power output:≤30W
Sensitivity:550
±
30mV
SNR≥70dB
Frequency response:20Hz-20KHZ.
Charging voltage: DC 9V 1.2A MAX.
Wireless Microphone Operation:(Limited to wireless version)
1.Switch ON / OFF:
◎Long press on the wireless microphone to switch on and the display will show a default frequency point.
Please open the speaker to amplify voice.
◎Long press on power on state will turn off the microphone and screen go out.
2. Pair the UHF Wireless MIC Manually(This pairing way is used when the MIC is no sound)
Step 1:
Turn on the speaker and find the “INPUT” button;
Step 2:
Switch on the wireless hand-held MIC and twist off the shell; then press “ ” &” ”at the same time for 3
seconds,until screen”
”indicator flashes;
Step 3:
Quickly short press the "INPUT" button for three times to enter into pairing status with a voice prompts "UHF" is
waiting for connection;
Step 4:
Please wait about 3s until the signal indicator””on the handheld mic from flashing to keep long lights. It means the
wireless mic pair successfully with the speaker.
Noted:Please finish pairing operation within 10s as the ” ” indicator can only flashes about 10s;
Noted: please don’t press the "INPUT" button to enter into“UHF” model after turn on the speaker;
Notes: Under the pairing status, long press “ ” &” ” on the hand-held microphone to disconnect wireless signal
with voice prompt “UHF is disconnected”. R epeat step 2& step 3 or pairing the UHF wireless MIC ma nually.
3.Battery Indication of UHF Wireless MIC:
In working status, it has sufficient battery power with indication showed on screen; it’s low battery with indication showed on screen and
please change the battery timely.
Note: Please open the battery cover properly and put the batteries. (Please note the positive & negative anode.)
SHENZHEN SHIDU DIGITAL CO.,LTD
21635866
29105099
Email:[email protected]
Website:www.10shidu.com
HaoWorks H2 User Manual
Solve some normal problems by yourself:
Trouble Possilble reasons Measures
Switch on the speaker but
no sound
1.Main machine is running out of
power
Please recharge it to switch on.
2.No audio input Please use another better audio
3.Haven’t turned on the volume Please adjust the volume properly.
With sound distortion
1.The volume is too high Please turn do wn the volume.
2.The speaker is broken Please contact us for maintenance.
No sound with Karaoke
1.Haven’t inserted the
wired MIC Please insert the wired MIC.
2.Haven’t switched on the MIC Please turn on the MIC
3.Haven’t turned on the MIC volume
4.The UHF wireless is disconnected or
wireless MIC is low battery
Please repair the UHF wireless microphone, Or please change the
battery
No sound with MP3 playing
1.The audio’s format in USB flash drive
or TF card is wrong
Please turn the format to MP3
2.Chaotic procedure with wrong
operation
Please restart the speaker
3.Haven’t inserted
drive/TF card properl
y
the USB flash
Please insert the USB/TF card properly.
Can only work several
minutes after charged or
have to w ork with Adapter
1.The battery is broken Please change a new sample battery
2.The connecting ca ble of battery is
loosened or disconnected
Please contact us for maintenance
3.Hasn’t full charged the speaker Please full charge it before using
Pair unsuccessfully 1. Turn on the speaker and enter into
“UHF” model firstly;
Please firstly turn on the wireless handheld mi
c and press the“ ”
“ ”
“ ”
“ ”
“ ”
“ ”&
“ ”
at the same time for 3 seconds until screen
ind ic at or
fla sh es;
Then quickly short press the "INPUT" button for three times to enter
into UHF model.
2. The indicator flasher turn on
light constantly before pairing;
Please finish pairing operation within 10s as the indicator can
only flashes about 10s; If the indicator flasher turn o n light
constantly before pairing, then please repeat step2 again to press the
“ ” “ ”& at the same time for 3 seconds until screen indicator
flashes;
SHENZHEN SHIDU DIGITAL CO.,LTD
21635866
29105099
Email:[email protected]
Website:www.10shidu.com
HaoWorks H2 User Manual
HaoWorks Guarantee:
30 days return and refund without any reason + 12-month warranty + Lifetime technical support
Please don’t forget to contact us at below for any assistance you needed.
[email protected]
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

SHIDU portable pa system User manual

portable pa system
Brand
SHIDU
Model
portable pa system
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents