Making a call
In direct dialing
1. Press .
2. Wait for the dial tone and then dial the
number.
In pre-dialing
1. Then dial the number. In case of error,
press Delete.
2. Press : the number is dialed.
Ending a call
1. Press .
Once the handset is replaced, the call
duration is displayed for 5 seconds.
If automatic hang-up is activated, the call is
terminated when the handset is returned to its
base.
Internal calls / internal call
Calling another handset
If you have more than one handset
registered to the database, you can make
internal calls between two handsets.
1. Press the int button (bottom right of
keypad) followed by the number of the
handset number (1 to 5) that you wish to
call.
2. Press OK to dial.
Note: When receiving an internal call, the
display shows Internal call handset X
(where X is the calling handset number).
Transfering a call
You can transfer an external call to
another handset registered on the base.
During the call:
1. Press the int button (bottom right of
keypad) followed by the number of the
handset number (1 to 5) that you wish to
call.
2. Press OK to dial or press End pour to
cancel the call request and return to the
caller.
3. When the other handset answers, you
can announce the caller.
4. Press to end the transfer or press
int to switch between the two callers.
Answering a call
Upon receipt of an external call, the
handset rings. The screen displays
External call and the subscriber number
or, if the number is stored in the
phonebook, the caller's name.
1. When the handset rings, press .
Note: an incoming call has priority over other
events. Thus, any operations in progress such as
phone setting, menu navigation, are immediately
discontinued.