2. Zebra
  3. TC8000
TC8000

Zebra TC8000 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Zebra TC8000 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Guide
Desk Mount
TC8000
2. Align plate mounting holes with holes in feet.
1. Secure three M2.5 studs into plate mounting holes.
2-Slot Desk Mount Assembly
5-Slot Desk Mount Assembly
Safety Screw
Studs (3)
Feet (2)
Plate
Screws with
Washers (4)
Feet (2)
Plate
Screws with
Washers (4)
Studs (4)
Safety Screws (2)
1. Secure four M2.5 studs into plate mounting holes.
2. Align plate mounting holes with holes in feet.
3. Secure plate to feet with four M5 screws and four
washers.
4. Secure power
supply to rear of
plate with tie
wraps.
6. Secure cradle to plate using two M5 safety screws.
5. Secure cradle to plate
using M3 safety screw.
6. Connect power supply.
3. Secure plate to feet with four M5 screws and four
washers.
4. Align mounting slot on bottom of cradle with studs on
plate.
Studs (3)
Studs (4)
5. Align mounting slot on bottom of cradle with studs on
plate.
7. Connect power supply.
NOTE:
The instructions in this guide provides installation
procedures for installing 2-Slot and 5-Slot cradles. The
illustrations shown are for a specific cradles. The actual look
and cable requirements may vary depending upon the
cradles you are installing.
NOTE: When mounting plate to rack, use screws provided with
rack system. Refer to rack user documentation for
instructions.
1. Secure four M2.5 studs to plate.
2. Install top two rack mount screws. Leave partially out half
way.
5-Slot Desk Mount on Rack
4. Install bottom two rack mount screws.
5. Secure all four rack mount screws.
6. Secure power supply to rear of plate with tie wraps.
7. Secure cradle to plate using two M5 safety screws
(provided with plate).
7. Connect power supply.
7. Align mounting slots on bottom of cradle with studs on
plate.
3. Align plate with the top two rack screws.
Rack Mount
Screws (2)
Rack Mount
Screws (2)
Safety Screws (2)
Zebra and the stylized Zebra head are trademarks of ZIH Corp., registered in many jurisdictions worldwide. All other
trademarks are the property of their respective owners.
© 2015 ZIH Corp and/or its affiliates. All rights reserved.
MN002413A01 Rev. A — November 2015
Zebra Technologies Corporation
3 Overlook Point
Lincolnshire, IL 60069, U.S.A.
/