Xerox 5335 Installation guide

1

English

Phaser 5335

Network Expansion Card

Installation Guide

Thank you for purchasing the network expansion card.

This guide is intended for first-time users and gives instructions on installing the product.

To ensure safe operation of the printer, be sure to read "Safety Notes" in the ‘User Guide’

before starting the installation.

WARNING

• This equipment has been designed to restrict operator access to safe areas only.

Operator access to hazardous areas is restricted with covers or guards, which would

require a tool to remove. Never remove these covers or guards.

Important

• Before plugging or unplugging the interface cable connector, be sure to switch off the printer or unplug

the power cord from the power outlet. Plugging or unplugging the connector when the printer is on can

cause printer failure.

• If installing the network expansion card when the printer is used in a network environment, the entire

network-related settings will be initialized to the defaults. Before installing the network expansion card,

we suggest yourecord the current settings by printing out the [Printer Settings] list. Refer to the ‘User

Guide’ on how to print the [Printer Settings] list.

Checking the Package Contents

The packaging box contains the following items. If you find any items missing, please

contact our Customer Support Center or your dealer.

• Network expansion card • 2 screws

•This guide

Part Number: 701P47286

Ver 1.0 December 2007

2

Installation Procedure

The network expansion card goes on the controller board right above additional memory

(optional). If you purchased additional memory, install it before installing the network

expansion card. For information on how to install additional memory, refer to the ‘User

Guide.’

Follow these steps when installing the network expansion card.

When uninstalling the network expansion card, use the reverse procedure described below.

1. Switch the power off by pressing the power

switch located on the front lower right of the

printer to the <O> position.

Unplug the power cord from the power

outlet and the printer.

2. Remove the cover plate on the rear side of

the printer. A coin may be used to loosen

any tight screws.

3. Remove the two screws that secure the

rear cover to the printer.

Additional memory

Network

expansion card

3

English

4. Pull the rear cover forward and remove it

from the printer.

5. Loosen the three screws that secure the

metal plate cover inside the printer.

6. Pull the metal plate cover forward and

remove it from the printer.

7. Align the connector of the network

expansion card with the card connector

(located at the left of the controller board)

and insert the card into the connector.

Important

• The connector at the right of the controller board is for

an internal hard disk (optional). Make sure to insert the

network expansion card into the correct connector.

8. Push the network expansion card as shown

in the figure and firmly insert it into the

connector. You may need to wiggle the

board slightly to get it to seat properly.

Card connector

4

9. Secure the card by hand-tightening the two

screws (supplied) on the outside of the

printer.

10. Re-attach the metal plate cover on the

printer by tightening the three screws

loosened in Step 4.

11. Re-attach the rear cover on the printer by

tightening the two screws removed in

Step 2.

12. Plug in the power cord and switch the power on by pressing the power switch to the

<|> position.

The installation is now complete.

Note

• You can check whether the network expansion card has been installed correctly by printing out the

[Printer Settings] list. Refer to "Printing the Reports/Lists" in the ‘User Guide’ on how to print the [Printer

Settings] list.

Page is loading ...

Xerox 5335 Installation guide

Xerox 5335 Installation guide

in other languages

Related papers

Other documents