7
G
Guarantee
ACCO Brands warrants its products and their parts against
defects in materials and workmanship under normal use for a
period of 24 months from the original date of purchase.
During this period we will repair or replace a defective product
or part subject to the following warranty conditions:
The warranty applies only to defects in materials and
workmanship under normal use and does not extend to
damage to the Product or parts which result from:-
alteration, repair, modification or service carried out by
anyone other than an authorised ACCO service centre.
accident, neglect, abuse or misuse owing to failure to
comply with the normal operating procedures for a product
of this type.
Nothing in this Warranty shall have the effect of excluding the
liability of ACCO in respect of death and personal injury caused
by the negligence of ACCO. This Warranty is offered (subject to
these terms and conditions) in addition to, and does not affect
your statutory rights.
Additional Guarantee
ACCO Brands guarantees the cutting blades of the shredder
to be free from defects in material and workmanship for
10 years on the RSS2030, RSX1630, RSM1130, RSS2232
and RSX1632 and for 20 years on the RDS2250, RDX1850,
RDM1150, RDM1170, RDSM750, RDSM770, RSS2270 and
RDX2070 from the date of purchase by the original consumer.
* Please note that the cutter blades will be progressively worn
down by shredding fastened sheets (staples and paperclips)
- this is not covered in the warranty. With regards to CD
shredding, Rexel departmental and small office shredders have
been designed to shred up to 500 and 300 CDs respectively
during the warranty period. Excessive cd shredding will wear
the cutters and is not covered within the warranty.
**Models RSM1130, RDM1150, RDM1170, RDSM750 and
RDSM770 have NOT been designed to shred CD’s, credit
cards, paper clips or staples. Any attempt to do so will
invalidate this warranty.
These conditions shall in all respects be governed and
construed in accordance with English Law and subject to the
exclusive jurisdiction of the English Courts.
Bin Full
When the bin is full the shredder will not function and the bin
full symbol will illuminate red.
When this happens you must empty the bin.
• Pull open the bin to empty (RSS2030, RSX1630, RSM1130,
RSS2232, RSX1632)
• Open the door and pull out the bag frame (RD2250,
RDX1850, RDM1150, RDM1170, RDSM750, RDSM770,
RDS2270, RDX2070)
Once the bin is empty, close the door/drawer and press the
auto button to resume shredding.
Note: RSX1630, RSX1632, RDX1850, RDX2070, RDM1150,
RDM1170, RDSM750, RDSM770 - Once the waste bag has
been reinserted and/or cabinet door has been closed, the
shredder will run in reverse for three seconds, stop for two
seconds and then forward for three seconds to clear away any
remaining paper from the cutter mechanism. This unique ‘self-
cleaning’ mechanism is additional jam prevention technology
from Rexel.
Shredder Accessories
We recommend that a paper waste sack for recycling shredded
paper is used on all models. Please see the table below for the
correct accessory code for your model.
Model Accessory Part Box
Description Number Qty
RSS2030 Recycling Waste Sack 2102063 20
RSX1630 Oil Sheets 2101949 20
RSM1130
RSS2232 Recycling Waste Sack 2102505 50
RSX1632 Oil Sheets 2101949 20
RDS2250 Recycling Waste Sack 2102441 50
RDX1850* AS1000 Plastic Waste Sack 40070 100
RDM1150*
Oil Sheets 2101949 20
RDSM750*
*Rexel Shredder Oil 1760049
RDS2270 Recycling Waste Sack 2102442 50
RDX2070* AS1000 Plastic Waste Sack 40070 100
RDM1170*
Oil Sheets 2101949 20
RDSM770*
*Rexel Shredder Oil 1760049
